Post a picture of your modified trim before you fit it  Gone to a good home: 2011 4.4 TDV8 Vogue SE Buckingham Blue with Ivory and clear glass = "Rory"
2025MY Defender D350 90 in Silicon Silver on coils
1974 Series 3 Lightweight = "Millie"
Many, many other Landies over the years
My preferred specialist: www.glenrands.co.uk
--------------------------------------------------

Dynax wax sprayed inside both sills via holes underneath. You can see it dripping out of the lower joint where there are small holes in the seam joints. Taped the vertical holes where the covers clips into with masking tape to avoid spray out! 1 tin did both sides.

Weegie wrote:

BMG wrote:

the lower two piece clips ( the ones where you are inserting a pin to expand ) .

Scrivets.

Not Scrivets. Plastic rivets are different ANR2224  Gone to a good home: 2011 4.4 TDV8 Vogue SE Buckingham Blue with Ivory and clear glass = "Rory"
2025MY Defender D350 90 in Silicon Silver on coils
1974 Series 3 Lightweight = "Millie"
Many, many other Landies over the years
My preferred specialist: www.glenrands.co.uk
--------------------------------------------------

Part number for the 2 scrivits that are at the rear into the wheel arch liner is DYQ100230.

DrRob wrote:

Weegie wrote:

BMG wrote:

the lower two piece clips ( the ones where you are inserting a pin to expand ) .

Scrivets.

Not Scrivets. Plastic rivets are different ANR2224

https://www.comdir.co.uk/scrivets-flush-head-type.html  John
2008 Stornoway Grey 3.6 Tdv8 Vogue
2005 TD6 Java Black Vogue - Written off!!
GAP iiD BT
2003 Discovery TD5 Auto, Nanocom Evolution - gone to a new home!
MasseyFerguson 152 - No electronics!! - Sold

DrRob wrote:

Post a picture of your modified trim before you fit it

Me and technology don't go together mate. I'll ask my daughter to post a picture in a bit.

Weegie wrote:

DrRob wrote:

Weegie wrote:

BMG wrote:

the lower two piece clips ( the ones where you are inserting a pin to expand ) .

Scrivets.

Not Scrivets. Plastic rivets are different ANR2224

https://www.comdir.co.uk/scrivets-flush-head-type.html

I like them. Better than the original prise out ones
They come in 8mm too
Cheers Weegie  Gone to a good home: 2011 4.4 TDV8 Vogue SE Buckingham Blue with Ivory and clear glass = "Rory"
2025MY Defender D350 90 in Silicon Silver on coils
1974 Series 3 Lightweight = "Millie"
Many, many other Landies over the years
My preferred specialist: www.glenrands.co.uk
--------------------------------------------------

Get yours checked and waxed inside! Gone to a good home: 2011 4.4 TDV8 Vogue SE Buckingham Blue with Ivory and clear glass = "Rory"
2025MY Defender D350 90 in Silicon Silver on coils
1974 Series 3 Lightweight = "Millie"
Many, many other Landies over the years
My preferred specialist: www.glenrands.co.uk
--------------------------------------------------

All done. I prefer the Freelander 2 trims cut to fit. They cover the lip a fraction more and also look more OEM. I couldn't get them to "join" the trailing edge ones due to the lip issue. I've smeared the small 2" area of exposed lip with clear waxoyl.

The new underside clips (ANR2224) were a swine to get in. Split them into 2 obviously to start with then tap in with a small hammer and wide drift but be careful not to hit too hard and break them!
I'd be tempted to try the one Weegie mentioned above
https://www.comdir.co.uk/scrivets-flush-head-type.html
8 x 22mm I think the original ANR2224 spec are: https://www.advancedfactors.co.uk/anr2224-...2758-p.asp Gone to a good home: 2011 4.4 TDV8 Vogue SE Buckingham Blue with Ivory and clear glass = "Rory"
2025MY Defender D350 90 in Silicon Silver on coils
1974 Series 3 Lightweight = "Millie"
Many, many other Landies over the years
My preferred specialist: www.glenrands.co.uk
--------------------------------------------------

Last edited by DrRob on 31st Mar 2021 7:35pm. Edited 2 times in total

I managed to treat both sides over the weekend. Thankfully not much rust, only some light surface patches. I treated with Kurust and then followed Matt's video with Hammerite and Waxoyl.

I had ordered some Dynax for the sill cavities but annoyingly it hadn't arrived in time and I wanted to get the job done before the rain this week. It's arrived today so will save that for another day!

I've also ordered a second set of the Freelander rubbers as I'm going to replace the original parts on the leading edge of the arch. The fit looks good and the originals look tired. I'm hoping this will also allow me to match up in the middle more cleanly.

I did have an interesting time with one of the wheel nuts though!

Click image to enlarge

Click image to enlarge

kevinp wrote:

DrRob wrote:

Post a picture of your modified trim before you fit it

Me and technology don't go together mate. I'll ask my daughter to post a picture in a bit.

Kev - any luck with a picture of your mod? I'm intrigued  Gone to a good home: 2011 4.4 TDV8 Vogue SE Buckingham Blue with Ivory and clear glass = "Rory"
2025MY Defender D350 90 in Silicon Silver on coils
1974 Series 3 Lightweight = "Millie"
Many, many other Landies over the years
My preferred specialist: www.glenrands.co.uk
--------------------------------------------------

Forgot to mention this earlier, but, when I cleaned my sills last week with the plastic trim off, I saw evidence of some sort of wax dribbling out of one of the grommets [same as in one of Dr Robs photo's] can one assume then that JLR treated the inner sills with waxoyl or similar from new?

Yes, they would have been treated at the factory. I’ve just topped it up
Fanders images also show “factory dribble”  Gone to a good home: 2011 4.4 TDV8 Vogue SE Buckingham Blue with Ivory and clear glass = "Rory"
2025MY Defender D350 90 in Silicon Silver on coils
1974 Series 3 Lightweight = "Millie"
Many, many other Landies over the years
My preferred specialist: www.glenrands.co.uk
--------------------------------------------------

Hi All!

Went out to put some replacement clips in a set of mud guards I fitted the other day. Then I remembered this thread, and that I'd already painted and wax injected the sills at the rear wheel arches. Soooo..... I stipped off the plastics to reveal watermarked but factory fresh sills.

Nice looking Supercharged Rangie! ---------------------------------------
2009 4.2 SC Buckingham Blue
2021 Hilux 2.4