fullfatrr.com - View topic - Just in time for winter...remote climate retrofit

Advertise on fullfatrr.com »

Forum · Gallery · Wiki · Shop · Sponsors

Home · FAQ · New Posts · My Posts · PMs · Search · Members · Map · Calendar · Profile · Donate · Register · Log In

Home > Maintenance & Mods (L405) > Just in time for winter...remote climate retrofit

Page 2 of 8

Print this entire topic ·

knwatkins

Member Since: 11 Sep 2020
Location: Poole, Dorset
Posts: 768

2014 Range Rover Vogue SE SDV8 Corris Grey

As promised...

This is a tutorial on adding timed climate and remote park heat to your L405 Range Rover.
Note, your vehicle must have the fuel burning heater installed to perform this modification. You can identify if your vehicle has this by looking under the bonnet and physically inspecting if it is present, as circled in the below image.

Click image to enlarge

The parts you require are:
LR033462 - Receiver - Auxiliary Fuel Heater (manufacturer part no. CPLA18D540AA)

LR033464 - Land Rover Remote Control Unit (manufacturer part no. CPLA18D539AA)

A suitable diagnostics tool to configure the car configuration file (CCF), for example the GAP IID tool.

Click image to enlarge

If the option is fitted at the factory, the receiver is fitted at the base of the of the D pillar as shown below. This is where the wiring is therefore terminated.

Click image to enlarge

Remove the right hand side luggage compartment. It is held in by three trim clips at the top.

Click image to enlarge

Locate the two connectors (one for power and control, the other for the antenna) for the receiver at the base of the D pillar. See arrow in the image below. You will notice that they are taped to the loom. Unpeel the tape to provide yourself with a bit of slack on the cables.

Click image to enlarge

If you want, you could choose to install the receiver in the factory-fit position. This would involve removing the D pillar trim and also the steel trim behind this to access. For me, I decided it was not worth the effort, as the receiver could simply be mounted securely in the below position with some good quality double sided adhesive pads.

Click image to enlarge

The next step is to update the CCF using a suitable diagnostic tool. For me, as I have the GAP IID tool, I used this and configured the following parameters:
Car Config > BCM-Body Control > Fuel Burning Heater > Fuel Fired Parking Heater
Car Config > BCM-Body Control > Timed Climate > Fitted

Then, the final step is to pair the remote with the receiver…
Lower the glovebox by pushing downwards on the stays either side to access the Central Junction Box (CJB).
Remove fuse 1 (5A), circled below, for at least 5 seconds, before re-installing it.

Click image to enlarge

Then, hold down the OFF button on the remote control.
The remote LED will illuminate red for 2 seconds to indicate successful pairing with the receiver.

You will also now notice you have a 'Timed Climate' option on your touch screen under 'Extra Features'. This will enable you to set a timer for when the fuel burning heater fires up on a 7 day schedule.

Job done

Kev

2014 L405 RR Vogue SE 4.4 SDV8 in Corris Grey
2010 L320 RRS HSE 3.0 TDV6 in Stornoway Grey

10th Oct 2020 8:30pm

davidmg

Member Since: 29 Mar 2013
Location: Nottinghamshire
Posts: 63

2017 Range Rover Autobiography 5.0 SC V8 Carpathian Grey

Thank you, that's perfect 2004 4.2 SC Japan Spec
2004 4.2 SC
2004 4.4 AJV8

10th Oct 2020 8:36pm

stan
Site Moderator

Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35274

thanks Kev, added to our wiki.. ... - .- -.

Y. O. L. O.
.

10th Oct 2020 9:02pm

horse86

Member Since: 09 Dec 2014
Location: PA
Posts: 860

2014 Range Rover Autobiography 5.0 SC V8 Causeway Grey

I just checked and I don’t have all that piping looking gizmo under the hood but I do have 2 the plugs/sockets where I’m assuming the heater plugs into. Would I be able to install this then? It looks like it has the wiring for it 2014 FF Autobiography 5.0 SC
2008 FFRR (sold)
2008 BMW M5

10th Oct 2020 10:27pm

Cam-Tech-Craig

Member Since: 03 Aug 2011
Location: Gloucestershire
Posts: 16284

2015 Range Rover SVAutobiography SDV8 Loire Blue

AHEM! A British car has a Bonnet Mr Horse...

What is this Hood you refer to?

10th Oct 2020 10:42pm

horse86

Member Since: 09 Dec 2014
Location: PA
Posts: 860

Haha. Ah yes sometimes I forget which forum I’m on 😉.

Well a baby wears a bonnet 2014 FF Autobiography 5.0 SC
2008 FFRR (sold)
2008 BMW M5

10th Oct 2020 10:48pm

Cam-Tech-Craig

Member Since: 03 Aug 2011
Location: Gloucestershire
Posts: 16284

& a Youth wears a Hood..ie

10th Oct 2020 10:52pm

horse86

Member Since: 09 Dec 2014
Location: PA
Posts: 860

Lol 2014 FF Autobiography 5.0 SC
2008 FFRR (sold)
2008 BMW M5

11th Oct 2020 5:48pm

Dave G

Member Since: 30 Jul 2020
Location: Dorset
Posts: 84

2013 Range Rover Autobiography SDV8 Indus Silver

Great post, seriously tempted to do this upgrade

11th Oct 2020 6:09pm

dolph34

Member Since: 14 Sep 2015
Location: Kildare
Posts: 1724

2015 Range Rover Autobiography SDV8 Corris Grey

I did this on my 2007 but had to fit an aerial for the receiver. All the other wiring was there but no aerial. 2015 4.4 AB
GSXR 1000 K5
R1 1998

11th Oct 2020 8:31pm

horse86

Member Since: 09 Dec 2014
Location: PA
Posts: 860

So I’m still unclear of how this actually works and if it can be retrofitted on US ranges?? Like I mentioned I have that large grey plug engine baY that’s circled but I’m missing the hoses around it.

Fuel burning where is the heating element and how does it put heat into the cabin?

Edit: just had another look in my engine bay and compared with the pic above. Looks like the hoses it the actual fuel burner and the hose/duct going back toward the firewall pUshes the hot air to the vents inside. I don’t have any of that and it’s just an empty cavity there so I guess I’m SOL even though it looks like I have the wiring in place 2014 FF Autobiography 5.0 SC
2008 FFRR (sold)
2008 BMW M5

11th Oct 2020 10:24pm

knwatkins

Member Since: 11 Sep 2020
Location: Poole, Dorset
Posts: 768

The FBH runs on diesel and not petrol/gasoline so not in your case I'm afraid

It works by heating up the coolant and then pumping the coolant through the matrix where the heat can then be blown into the cabin. Kev

2014 L405 RR Vogue SE 4.4 SDV8 in Corris Grey
2010 L320 RRS HSE 3.0 TDV6 in Stornoway Grey

12th Oct 2020 3:28am

aljo

Member Since: 04 Jul 2018
Location: west sussex
Posts: 202

2019 Range Rover Vogue SE 2.0 PHEV Santorini Black

Excellent write up 👍👍👍 Last night I lay in bed looking up at the stars in the sky and I thought to myself, where,s the f**king ceiling!!

12th Oct 2020 7:46am

Dolphinboy

Member Since: 07 Dec 2009
Location: Bristol
Posts: 3137

2011 Range Rover Vogue TDV8 Atacama Sand

Horse you can get petrol FBH- I have it on my 2004 petrol V8. It’s a webasto. I’m sure you could get one your side.

12th Oct 2020 8:36am

knwatkins

Member Since: 11 Sep 2020
Location: Poole, Dorset
Posts: 768

Remember the L405 does not use a Webasto FBH. It uses Eberspächer.

Eberspächer may have something though. Kev

2014 L405 RR Vogue SE 4.4 SDV8 in Corris Grey
2010 L320 RRS HSE 3.0 TDV6 in Stornoway Grey

12th Oct 2020 8:51am

Page 2 of 8

All times are GMT

Jump to

< Previous Topic | Next Topic >

Posting Rules

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum