They seem to clog to the point where they are a plug very suddenly!

Thanks for this info, my brothers TDv8 had this problem for a while, really simple fix when you know what to look for. His well chuffed, as its saved a rip off trip to a garage. Thanks

There is a modified part from LR (ask Dan) with a hole in it already... Been an issue for years We check and change them on major services if still fitted with the old type... Approx £7 from main dealer If I remember correctly...

I'm sure Dan will ad a part number when he reads this thread...

And very easy to drill your existing one....

Why bother when you can fit an inexpensive new JLR approved part

Last edited by Cam-Tech-Craig on 19th Jan 2014 2:19pm. Edited 1 time in total

Because when it happens chances are you will not have the new JLR approved part. Drilling (or simply removing) takes a few minutes and your cured and can continue your journey (you may be in Outer Mongolia). By all means then order a spanking new JLR part

PS: If your fitting them nearly every day why don't you know the part number you must be getting them from JLR?

Last edited by Gazellio @ Prestige Cars on 19th Jan 2014 2:21pm. Edited 1 time in total

Ok Gary... Well done you

If you make "rolling eye" comments on my threads please expect me to make common sense replies

It's common sence for forum members to perform preventative maintenance and fit a revised inexpensive part before a breakdown situation in my eyes...

But hay ho, if you want to try to pick fault every post... Whatever!

Sorry Craig I reminded poster of the simple drill fix in a friendly manner and YOU came in with rolling eyes?

OK, So does anyone know the part number for the modified filter, so I can order one in and fit it as preventive maintenance please, Or will Dan supply me 2 please?

Thanks Gaz, ordered from Amazon and replaced this morning - old filter wasn't too bad but air flows through the new filter a bit easier

Top bit of preventative maintenance and for £3.50 I now have four spare filters!

Biggest part of the job was removing the spare - I think I will be purchasing an extraction kit from Dan! 2007 Zermatt Silver TDV8 Vogue SE - now sold but was a great car!

Hi Tassie

Yes you have the earlier compressor model (like me) and like me the brass filter doesn't have a hex to easily remove. I had a go with some pliers but didn't try too hard as I didn't have a spare to hand, so not sure how easily it will come out or if it is on a thread!

You could always remove and drill out in situ as it were. Because it is an exhaust filter it will blow out any debris (?)

- [EDIT] done a bit of research, no thread on the early models, it is a ribbed press fit and wil take some tugging, turning and wobbling to get out.


Does your compressor run OK? Do you have any faults on dash or via diagnostics? Would seem a reset of some kind might clear things. Have you tried a battery disconnection? .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999