Yes, should be a 2 minute job now when the bits arrive  Paul

2014 Range Rover vogue se 4.4sdv8 Loire Blue
1992 Range Rover Vogue LSE 4.2 Ardennes green

marsie wrote:

Just ordered the module and remote for mine, already done the CCF edit and got the timed climate option on the screen so just need to wait for the bits to turn up now. Then wait for cold weather

Paid a bit more for the bits (£70 for the module and £30 for a new key fob) but still a cheap mod
Thanks for the info and writeup Kev, another gadget added to the list
Paul

No probs Paul

It's useful little mod and having had the functionality on my old RRS, it's something I cannot do without now!  Kev

2014 L405 RR Vogue SE 4.4 SDV8 in Corris Grey
2010 L320 RRS HSE 3.0 TDV6 in Stornoway Grey

I had it on my D4 and I think when the cold weather comes I would miss it too. Its nice not having to wait to defrost windows  Paul

2014 Range Rover vogue se 4.4sdv8 Loire Blue
1992 Range Rover Vogue LSE 4.2 Ardennes green

All done, fitted and programmed and wiring for the snow . Thanks again to Kev for the writeup  Paul

2014 Range Rover vogue se 4.4sdv8 Loire Blue
1992 Range Rover Vogue LSE 4.2 Ardennes green

Had all summer to sort my retro heating fit after i didnt getting it going last winter due to an open circuit on the aux water pump but i thought i would wait till i could stand in the cold again to try and sort it , would anyone know if 12v and an earth should bring the pump to life, i have noticed on pictures of the pump that it has 3 pins in the plug socket but only 2 wires feed it. Thanks for any info.

Hi all fitted the parts and paired remote but it will only work if am stood next to back piller any one any ideas as to why

Thanks

Check the antenna connections

I don't get a very good range on mine to be honest. It's fine for my needs, and will work between my hallway and car, but if I move into my kitchen, it doesn't reach. On my old L320, the range was crazy. I could have been in the middle of the supermarket and it would reach out to the car park. Kev

2014 L405 RR Vogue SE 4.4 SDV8 in Corris Grey
2010 L320 RRS HSE 3.0 TDV6 in Stornoway Grey

stan wrote:

thanks Kev, added to our wiki..

No problem

Just on the range issue, what I didn't check was that the coax antenna cable is actually plugged into the TV amplifier module at the other end. It may not be if remote climate wasn't installed at the factory! If anyone checks this and finds out, please report back and I'll update the tutorial. Kev

2014 L405 RR Vogue SE 4.4 SDV8 in Corris Grey
2010 L320 RRS HSE 3.0 TDV6 in Stornoway Grey

this any help?

https://www.webasto.com/fileadmin/webasto_...rt-t91.pdf

knwatkins wrote:

The next step is to update the CCF using a suitable diagnostic tool. For me, as I have the GAP IID tool, I used this and configured the following parameters:
Car Config > BCM-Body Control > Fuel Burning Heater > Fuel Fired Parking Heater
Car Config > BCM-Body Control > Timed Climate > Fitted

Ran my test timed climate this morning.

Got into the car after 25 mins of the FBH running and ...

... air was being blown around the car but the windscreen was still frozen solid.

Looking at the bonnet, the corner over the FBH was defrosted, so have to assume the heater was running.

Did I just not give it enough time? What do I put here then?

Strange. My windscreen is always defrosted by the time I get out to the car. Mind you, I think last night was particularly chilly. Just whack your heated front screen on. Should be melted in a few minutes  Kev

2014 L405 RR Vogue SE 4.4 SDV8 in Corris Grey
2010 L320 RRS HSE 3.0 TDV6 in Stornoway Grey

My L322 used to always clear the screen too.

I think - well hope - you’re right about last night being so cold.

Going to give it another test on the next frosty night, making sure it gets its full run time. What do I put here then?