Advertise on fullfatrr.com »

Home > Technical (L322) > Front Blowers and FSR - Next Steps?
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
RovingCanary



Member Since: 20 Dec 2023
Location: Somerset
Posts: 71

United Kingdom 2012 Range Rover Westminster 4.4 V8 Santorini Black
Front Blowers and FSR - Next Steps?

Hello, a couple of weeks ago my front blowers stopped working (all lights and controls working fine). I read around a fair few threads and just replaced the Final Stage Resistor with a £30 aftermarket one...

It worked fine for about 10 minutes, then must have burned out as the fans came on maximum even with HVAC turned off, and then stayed on after I turned off the car.

Strangely, I put the old one back in and it it worked normally again.

I suspect there is something up with the blower unit, as it occasionally makes a little bit of noise. and a loudish droney noise if I turn it onto maximum.

Does anyone have any tips on next steps? Ideally wanted to avoid stripping down the whole dashboard , but has anyone had a similar scenario and successfully cleaned up contacts or anything? Or is a replacement blower unit inevitable Shocked

Post #685464 12th Feb 2024 5:05pm
View user's profile Send private message View poster's gallery Reply with quote
pjw888



Member Since: 04 May 2023
Location: Dumfries
Posts: 25

United Kingdom 2011 Range Rover Autobiography 4.4 V8 Stornoway Grey

Hi, lots of info on site. Normally a motor problem. There is a really good descriptive procedure on here, it may be in WIKI. For the cost of a motor, I'd just replace. I believe there is a BMW alternative at decent prices

Post #685468 12th Feb 2024 6:13pm
View user's profile Send private message View poster's gallery Reply with quote
DrRob



Member Since: 16 Apr 2015
Location: Petersfield, Hampshire
Posts: 4298

United Kingdom 2011 Range Rover Vogue SE TDV8 Buckingham Blue

Bite the bullet and get a new fan installed

https://www.fullfatrr.com/forum/topic67642.html

Thumbs Up Gone to a good home: 2011 4.4 TDV8 Vogue SE Buckingham Blue with Ivory and clear glass = "Rory"
2025MY Defender D350 90 in Silicon Silver on coils
1974 Series 3 Lightweight = "Millie"
Many, many other Landies over the years
My preferred specialist: www.glenrands.co.uk
--------------------------------------------------

Post #685469 12th Feb 2024 6:15pm
View user's profile Send private message View poster's gallery Reply with quote
RovingCanary



Member Since: 20 Dec 2023
Location: Somerset
Posts: 71

United Kingdom 2012 Range Rover Westminster 4.4 V8 Santorini Black

Cheers guys, yes cheap though I think it will take me significantly longer than 5 hours! Embarassed

Will get a part ordered, hopefully it will last until the days get a little longer !

Post #685472 12th Feb 2024 6:34pm
View user's profile Send private message View poster's gallery Reply with quote
CS



Member Since: 14 Apr 2015
Location: Edinburgh
Posts: 1372

Scotland 2017 Range Rover Autobiography 5.0 SC V8 Corris Grey

When this happened to mine there was also a need to free up and lubricate the moving parts that direct where the heated air goes, sorry to be so non-technical in the description. Only Range Rovers since 1988

Post #685474 12th Feb 2024 7:23pm
View user's profile Send private message View poster's gallery Reply with quote
RovingCanary



Member Since: 20 Dec 2023
Location: Somerset
Posts: 71

United Kingdom 2012 Range Rover Westminster 4.4 V8 Santorini Black

Thanks CS, the duct actuators(?) seem to be working fine at the moment, however while I am in there it sounds a great idea to lubricate as well. What did you use, silicone grease?

Post #685476 12th Feb 2024 7:46pm
View user's profile Send private message View poster's gallery Reply with quote
CS



Member Since: 14 Apr 2015
Location: Edinburgh
Posts: 1372

Scotland 2017 Range Rover Autobiography 5.0 SC V8 Corris Grey

It was done by the dealers, so I'm not sure, sorry. Only Range Rovers since 1988

Post #685477 12th Feb 2024 7:51pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site