Advertise on fullfatrr.com »

Home > Search
Search found 11 matches

Topic Starter Message
 Rear lamp moisture an intresting fix
Stevie_b

Post18th May 2018 6:06pm
Forum: Maintenance & Mods (L322) · Replies: 4 · Views: 3016 · Subject: Rear lamp moisture an intresting fix
SausageCreature
Sheer frikking genius Smile Love it
Cheers mate..

wood78987
Great idea. Where did you position the vacuum hose?
Is there a drain bung somewhere?

If you have holes already d ...
 Rear lamp moisture an intresting fix
Stevie_b

Post13th May 2018 9:50pm
Forum: Maintenance & Mods (L322) · Replies: 4 · Views: 3016 · Subject: Rear lamp moisture an intresting fix
Ok so my lamps have had moisture in them pretty much since i got her. I sealed them both but the l/h still had water in it as well as mould along the lower edge.
I had the idea of using a small vacuu ...
 Aircon compressor voltage
Stevie_b

Post12th May 2018 3:47pm
Forum: Technical (L322) · Replies: 8 · Views: 2404 · Subject: Aircon compressor voltage
Is the compressor drive belt intact? Just a thought!
Usually it's down to low refrigerant.
Looking at the circuit diagram the compressor is feed directly from the ATC module.
The green yellow is t ...
 Td6 low pressure rail
Stevie_b

Post7th Mar 2018 9:26pm
Forum: Technical (L322) · Replies: 4 · Views: 1632 · Subject: Td6 low pressure rail
From memory 300kpa before it'll inject fuel, it's usually the secondary pump on the side of the tank which causes problems. How much fuel is in the tank and do you see air being purged through the pip ...
 Airbag ECU
Stevie_b

Post23rd Feb 2018 6:44pm
Forum: Maintenance & Mods (L322) · Replies: 3 · Views: 1595 · Subject: Airbag ECU
Hi mercs, I probably don't have to tell you, remember to disconnect the battery and leave for 20 minutes before doing any work on the srs system and disconnect the module connectors before removing fr ...
 [solved] Where should this connect to?
Stevie_b

Post16th Jan 2018 9:23pm
Forum: Technical (L322) · Replies: 10 · Views: 3419 · Subject: [solved] Where should this connect to?
No bother, good luck in the repair.


Stevie.
 [solved] Where should this connect to?
Stevie_b

Post15th Jan 2018 10:49pm
Forum: Technical (L322) · Replies: 10 · Views: 3419 · Subject: [solved] Where should this connect to?
Hi, I'm sure it connects to a pipe on the air box Very Happy



Stevie.
 Sending my L322 to sleep with me in it. Is it possible?
Stevie_b

Post8th Jan 2018 6:54pm
Forum: Technical (L322) · Replies: 8 · Views: 4873 · Subject: Sending my L322 to sleep with me in it. Is it possible?
Hi NVB, you could latch the doors and tailgate instead of closing them and either single press the lock button on the remote or double press to disable the ultrasonics (I can't remember which) or rem ...
 does the td6 have a MAP sensor ?
Stevie_b

Post10th Sep 2017 6:10pm
Forum: Maintenance & Mods (L322) · Replies: 5 · Views: 2745 · Subject: does the td6 have a MAP sensor ?
Right down the back of the manifold you'll probably need to remove the pollen filter box to see the it...
Regards...
 does the td6 have a MAP sensor ?
Stevie_b

Post9th Sep 2017 1:16pm
Forum: Maintenance & Mods (L322) · Replies: 5 · Views: 2745 · Subject: does the td6 have a MAP sensor ?
Back of the inlet manifold.. from memory ..
Regards.
 Engine warning on dash
Stevie_b

Post31st Mar 2017 5:07pm
Forum: Technical (L322) · Replies: 8 · Views: 2806 · Subject: Engine warning on dash
Most likely.Engine system fault, you need the codes read to identify the possible cause...
Hopefully something simple. Although...
 
All times are GMT

Jump to  
Page 1 of 1



Site Copyright © 2006-2025 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site