Hello guys.
I tried searching but only found Fsr problems and since my fan seems to be working perfect on all steps when I put it through the manual steps this can't be fsr right?
If I start the car and have it in auto mode I can't hear the fan nor feel any breeze coming through any vent even if I drive it til the engine is normal temp.
It did not do this until afew weeks ago, normally it blows hard until the car is warm inside.
Any info/help on this is greatly appereciated.

[/img] 2010MY TDV8 Vogue Nara bronze / Arabica, Ivory. VW Amarok 2013 180 auto
Swedish LR club member #5333

is the temp set high enough for the auto to kick in.. ... - .- -.




Y. O. L. O.
.

Yes, inside is on 22c and outside is -2c 2010MY TDV8 Vogue Nara bronze / Arabica, Ivory. VW Amarok 2013 180 auto
Swedish LR club member #5333

Mine doesn't light up on auto but I think it does the blowing job - ohh err missis  Geoff

Well well, It seems the old FF mended itself overnight, today it works as it should again, are these the best cars ever built or what!  2010MY TDV8 Vogue Nara bronze / Arabica, Ivory. VW Amarok 2013 180 auto
Swedish LR club member #5333

It is programmed not to blow air until it has reached temperature. Mine does the same...it's so you don't get even colder!

I remember that as well what AB just said, it waits for sufficient warm air / coolant heat is available before starting the fan. Keep an eye on the engine temp vs. the starting of the fan in auto .

Do you have a stand still heater installed as well, I mean the "cold country electric heater" and is it a electric fan in the interior or also an engine coolant heater type ?? MY 2010 5.0 SC Galway green and sand interior!!
Have the Faultmate MSV2 Extreme to be tinkering with the settings etc. !!