I decided earlier in the week having seen the images from Gaz after Harvey123 performed a detail on one of his cars to get mine looked at.

Drove the 85 miles over to his in an easy drive this morning. Met up outside his house where he set to work. First wash a rinse and snow foam. then a rinse and a dry. (my sone and i wondered off to the park for this bit so it was done when we got back)

Out came the DA polisher and he set to work removing the light scratches and swirls marks I had. Although the car was in relatively good shape anyway it needed some attention here.

All I can say is what a terrific job he did. Finally finishing off with a seal so it should be protected for a few months at least. I only had my iPhone so the pics aren;t great quality but to say I was pleased as punch was an under statement. It looks marvellous.

Many Thanks Harvey.. Great to see you again and a stunning job you did. Very pleased mate..!!

I would highly recommend you to anyone of the forum who's full fat is need of some TLC.








 Ash
------------------------------------------------------
2022 SDV8 AB
2016 TDV8 VSE
2011 TDV8 VSE
2006 V8 Vogue
2002 2.5 Vogue

Cheers ash

Glad you were happy with the job  Range Rover Autobiography Black Conversion

Sure am. I didn't rain on the way home which was a bonus so she was all tucked up in the garage last night and still looks clean this morning despite the 85 miles trip home..!

Thanks again! Ash
------------------------------------------------------
2022 SDV8 AB
2016 TDV8 VSE
2011 TDV8 VSE
2006 V8 Vogue
2002 2.5 Vogue

Super job good to see members using other members for services  Present :2008 TDV8 HSE
Gone Audi A5 2.7TDI
Gone Discovery 3 HSE
Gone Mercedes CLK
Gone Range Rover 2.5 DSE

Car looks great

You need some new wheel nuts though

Did I read somewhere that you can buy wheel nut and/ or locking wheel nut covers?

I know. embarrassed to say I have brown nuts...!

need to change them but they are not that cheap if I remember rightly? Ash
------------------------------------------------------
2022 SDV8 AB
2016 TDV8 VSE
2011 TDV8 VSE
2006 V8 Vogue
2002 2.5 Vogue

correct Ash they are expensive..you could coat them with some silver spray until the right deal comes along.. ... - .- -.




Y. O. L. O.
.

Aren't they the wrong nuts for the wheels ?

I thought it was only the pre-05 nuts that rusted.

With those wheels you should have the later nuts anyway and they are silver.

If you're running the wrong nut's then they are likely to shake themselves loose !

that's a very valid point Alistair..  ... - .- -.




Y. O. L. O.
.

I must assume from the comments that the wheels are post 05..? The car is pre 05 (54 plate) Ash
------------------------------------------------------
2022 SDV8 AB
2016 TDV8 VSE
2011 TDV8 VSE
2006 V8 Vogue
2002 2.5 Vogue

And if they are wrong - would these be the fellas I need

linky  Ash
------------------------------------------------------
2022 SDV8 AB
2016 TDV8 VSE
2011 TDV8 VSE
2006 V8 Vogue
2002 2.5 Vogue

correct on both counts..

for safetys sake i would undo one nut and check its shank size.. ... - .- -.




Y. O. L. O.
.

Yep - those are ~2010 wheels - That assumes the wheels are genuine & not copies......

The thread for the nuts is the same, but the later wheels had a larger bore - so the old nuts fit, they're just too loose

Thread here

Basically you need the nuts to match the wheels & not the car.

Many thanks Stan and Alistair.

I will go ahead and order a set in the link (unless someone tells me they can be bought cheaper/better elsewhere) Ash
------------------------------------------------------
2022 SDV8 AB
2016 TDV8 VSE
2011 TDV8 VSE
2006 V8 Vogue
2002 2.5 Vogue