Hi all,
Still new to the forum so apologies if I go astray or this is covered elsewhere.

I'm looking at purchasing a 2006/55 SC that appears to be in quite good condition.
One of the things I picked up though was what looks like a bulg in the lower section of the rear drivers side door.
I couldn't make out any other damage, scratches or marks just a strange bulge in the "plastic" section??

Any ideas what this could be and are these panels easy to fix/replace??

Also the reversing cam is very temperamental and refuses to work most of the time.
Again is this an easy fix or replace?? I've noted on some forums retrofitting non OEM cameras, I just wasn't sure if this was a known problem or not.

Thanks in advance.

Mike

When I say I noticed a bulg I meant a bulge!!

Mike

The lower door panels are plastic clip on jobbies, so yes, you could pop it off, see what the bulge is and potentially replace. Discovery 4 HSE
1998 110 TUM HS FFR Hard Top XD WOLF
1982 Series 3 Hard Top

*Gone:L462 D5 HSE LUX, L663 Defender 110 HSE, Discovery 3 HSE, 2014MY Range Rover Sport 5.0 Supercharged AB Dynamic; L405 Exec Vogue SE 4.4, 5.0 Supercharged Autobiography, Defender TDCi XS CSW, Defender TD5 HT, Vogue SE TDV8, Vogue TD6, RRSport SC 4.2V8, Classic 3.9 Vogue Auto, Land Rover Series 3 SWB

It would be easy enough to remove the inner door panel to see if there is any damage to the door panel behind. Tom

Current Drive
2011 4.4 TDV8 Autobiography - Santorini Black - Ivory Leather

Previous Drives
2004 Model Vogue Td6 (Touchscreen) - Java Black - Parchment Leather
1994 RR Classic 3.9 V8 Soft dash - Niagara Grey - Grey Leather
1972 Series III SWB Safari - Green (Hand Painted) - Black Plastic

Here you go:

Click image to enlarge

^^ what they said re the bulge and the rear view camera isnt the best quality and some have repaired or replaced ..how to is in the wiki.. ... - .- -.




Y. O. L. O.
.

What service

Is there any particular bonding tape to use when putting back together?

Mostly just watch out you don't break the clips as they are pretty brittle at best , if you need tape 3M double sided tape will do

It's best to get the door card off and squeeze the white nylon clips inwards and outwards, just pulling at the panel/ clips can break the thinnest part of the panel where the clip sits.... If it does, a blob of non- setting body sealant will replace an odd missing clip. For future ref -- On the rear doors, there is a little screw right at the trailing edge as well as the clips.

Thanks guys.
All sounds manageable so might have another look at this one.