Advertise on fullfatrr.com »

Home > In Car Electronics (L322) > Headlamp Wiring Advice Needed?
Post Reply  Down to end
Page 1 of 2 12>
Print this entire topic · 
Joe90



Member Since: 29 Apr 2010
Location: Hampshire
Posts: 6408

England 
Headlamp Wiring Advice Needed?

Need to hack into the headlamp wiring to set up my fogs as DRLs. There are warnings everywhere about the 25000 volts on the bi-xenons so want to make sure I get this right!

I need to pick up an ignition feed (to turn on the DRLs) and a "switched on" feed (to turn the DRLs off when the headlights come on)

RH Headlamp Wiring

Click image to enlarge


LH Headlamp Wiring
Click image to enlarge


Reading the Electrical Library pdf it says that an ignition feed is fed to both headlamps by a RED/GREEN wire. This tallies as there is a RED/GREEN wire going to both. (see pictures)

The Electrical Library then says the "switched on" feed is through a YELLOW/BLUE for the RH side and WHITE/GREEN for the left. These are thicker than the RED/GREEN wires. (see pictures)

Can anyone confirm I am on the right lines, before I blow myself or the car up Wink .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember Wink
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Post #117797 16th Apr 2012 5:51pm
View user's profile Send private message View poster's gallery Reply with quote
stan
Site Moderator


Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35272

United Kingdom 

i wish i took notice of my set up tim.....stick a multimeter in the headlamp plug and do the usual like turning on the ignition and read the readings .. ... - .- -.




Y. O. L. O.
.

Post #117807 16th Apr 2012 7:37pm
View user's profile Send private message View poster's gallery Reply with quote
stan
Site Moderator


Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35272

United Kingdom 

i'll have a look at mine tomorrow... Thumbs Up ... - .- -.




Y. O. L. O.
.

Post #117814 16th Apr 2012 7:46pm
View user's profile Send private message View poster's gallery Reply with quote
DMRR



Member Since: 14 Apr 2010
Location: Northamptonshire
Posts: 2027

South Africa 2009 Range Rover Westminster TDV8 Stornoway Grey

Slight hi-jack - Can you retrofit bi-xenons? My TDV8 has standard halogens Rolling Eyes Land Rover Addict
XXXXXXXXXXXXXXXXXXXXXXX

Previous
XXXXXXXXXXXXXXXX
2009 5.0V8SC Autobiography
2006 4.2V8SC Autobiography
2004 4.4V8 Vogue

Post #117820 16th Apr 2012 8:17pm
View user's profile Send private message View poster's gallery Reply with quote
Joe90



Member Since: 29 Apr 2010
Location: Hampshire
Posts: 6408

England 

stan wrote:
i wish i took notice of my set up tim.....stick a multimeter in the headlamp plug and do the usual like turning on the ignition and read the readings ..


But what about the 25000 volts Twisted Evil .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember Wink
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Post #117821 16th Apr 2012 8:21pm
View user's profile Send private message View poster's gallery Reply with quote
Joe90



Member Since: 29 Apr 2010
Location: Hampshire
Posts: 6408

England 

DMRR wrote:
Slight hi-jack - Can you retrofit bi-xenons? My TDV8 has standard halogens Rolling Eyes


The description of the wiring and feeds for halogen and bi-xenon appears to be the same, but i don't know enough about it to say yeah or nay. Suggest start a new thread for this? Wink .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember Wink
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Post #117822 16th Apr 2012 8:23pm
View user's profile Send private message View poster's gallery Reply with quote
Cam-Tech-Craig



Member Since: 03 Aug 2011
Location: Gloucestershire
Posts: 16284

England 2015 Range Rover SVAutobiography SDV8 Loire Blue

Joe, the high voltage is within your headlamp pal... The feeds to the plugs are all standard 12v, the ECU's and High voltage box is hidden inside the rear of your headlamp...

And yes the wiring colours you mentioned are the ones you want...




Craig Thumbs Up

Post #117840 16th Apr 2012 9:47pm
View user's profile Send private message View poster's gallery Reply with quote
simon1233



Member Since: 13 Jun 2011
Location: Leyland, sometimes Darmstadt
Posts: 650

United Kingdom 

DMRR wrote:
Slight hi-jack - Can you retrofit bi-xenons? My TDV8 has standard halogens Rolling Eyes


Really?

My tdv8 has xenons and I thought they all did Question

Are you talking about the separate high beams? If so, I believe it is normal for these to be halogen still - something to do with the fact that xenon doesn't come on instantaneously, important for flashing the lights - the main beam shifts it's pattern to be full beam slightly later

Post #117842 16th Apr 2012 10:12pm
View user's profile Send private message View poster's gallery Reply with quote
Cam-Tech-Craig



Member Since: 03 Aug 2011
Location: Gloucestershire
Posts: 16284

England 2015 Range Rover SVAutobiography SDV8 Loire Blue

In all L322's from 02-08 you can get both Xenon and Halogen headlamps depending on spec... Only the 09my> that comes with Xenon headlamps across the range...


Craig Thumbs Up

Post #117844 16th Apr 2012 10:31pm
View user's profile Send private message View poster's gallery Reply with quote
Joe90



Member Since: 29 Apr 2010
Location: Hampshire
Posts: 6408

England 

Cam-Tech-Craig wrote:
Joe, the high voltage is within your headlamp pal... The feeds to the plugs are all standard 12v, the ECU's and High voltage box is hidden inside the rear of your headlamp...

And yes the wiring colours you mentioned are the ones you want...




Craig Thumbs Up



Thank you for enlightening me, Craig - to work!! Thumbs Up .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember Wink
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Post #117846 16th Apr 2012 11:19pm
View user's profile Send private message View poster's gallery Reply with quote
stan
Site Moderator


Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35272

United Kingdom 

tim,

the high voltage only occurs from the ballast to the hid bulb, the ballast is fed by 12 volts which ends at the end of the plug .... ... - .- -.




Y. O. L. O.
.

Post #117851 17th Apr 2012 7:10am
View user's profile Send private message View poster's gallery Reply with quote
stan
Site Moderator


Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35272

United Kingdom 

ok, had a look but its all taped up pretty well but what i can see is that the ignition is green/brown and the headlight on feed is yellow/green.....hope this helps.. ... - .- -.




Y. O. L. O.
.

Post #117872 17th Apr 2012 9:21am
View user's profile Send private message View poster's gallery Reply with quote
Joe90



Member Since: 29 Apr 2010
Location: Hampshire
Posts: 6408

England 

LH side (Passenger side RHD)

YELLOW/GREEN stripe is the dipped beam
WHITE/GREEN stripe is the full beam

Thanks for your guidance Smile .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember Wink
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Post #117999 17th Apr 2012 5:21pm
View user's profile Send private message View poster's gallery Reply with quote
Joe90



Member Since: 29 Apr 2010
Location: Hampshire
Posts: 6408

England 

Is there an "easy" way to put the headlight unit back in. Seems you have to fiddle and struggle for 15 minutes, then suddenly it slots into place Evil or Very Mad .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember Wink
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Post #118007 17th Apr 2012 6:01pm
View user's profile Send private message View poster's gallery Reply with quote
stan
Site Moderator


Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35272

United Kingdom 

15 minutes is the easy way tim... Laughing ... - .- -.




Y. O. L. O.
.

Post #118025 17th Apr 2012 7:54pm
View user's profile Send private message View poster's gallery Reply with quote
Post Reply  Back to top
Page 1 of 2 12>
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site