hi guys really need some help ive had an ongoin issue with my 2003 td6 ,eas inactive to try to get to the bottom of it ive had new battery ,brought snap on ethos diagnostic ,iid tool cleared all faults [abs said air sus can bus ,eas said invalid articulation drive for around 20 miles then havto start all over again my question is how do you no which hight sensor is giving the problem ,it does not come up with left or right hight sensor faulty on diagnostics or am i missing somthing

The can bus issue is a generic fault on all of them and you can ignore it, if you have an IID tool you can check the operation of the height sensors (there are four of them) under live values, if they are faulty the IID tool usually has stored codes stating which one... Pete

__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Parchment over Navy Interior. Sold
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand, Jet Interior. Sold
2002 L322 Vogue 4.4 V8 Epson Green, Ivory over Aspen Interior (Fatty Offroader) Sold
-Click for Project Fatty off roader-

ok so looked at voltage and its showing LFRONT/RIGHT REAR VOLTS AS 0.05 BUT ON WHAT..... is there a wire that powers some sort of cross link :bow:yes i no there,s loads of wires ..

Um.... IID tool doesn't show voltage, it shows a reading from the sensor, how the reading moves when you rock the car gives an indication which one is going bad.... Pete

__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Parchment over Navy Interior. Sold
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand, Jet Interior. Sold
2002 L322 Vogue 4.4 V8 Epson Green, Ivory over Aspen Interior (Fatty Offroader) Sold
-Click for Project Fatty off roader-