Could anyone let me know of the correct on the road ride hight measurement from the bottom of the wheel arch to the centre of the wheel hub as my rear suspension seem to be low at the rear, i have just taken our horse trailer to have it serviced and the service centre tells me that the hight of the tow hitch is a bit low and having now had a look at the back of the RR it sits lower at the back than at the front, the suspension seems to go up and down ok from access hight to off road but it does seem a bit low at the back.

Seems to squat on the back.

Any help would be appreciated

i just quickly copied this from the workshop manual [download link in the wiki]

Thank you very much it is 40mm to low so i guess it needs some attention.

seems like..the IIDTool from GAP diagnostics will get it to whatever height you want, providing theres no underlying problems .. ... - .- -.




click link for ,

FORUM WIKI

HOW TO Ǝꓕ∀ꓕOꓤ PICS

workshop manual downloads are in our wiki

.

Got a ELM327 and a peace of software from RSW that will set up the bags up so they say, i will have to see if it works and report back here, having a nightmare with the people i bought the car off as it is under warranty and they say there is nothing wrong with it although is is 40mm lower than it should be.

Note for SC "club members" ride height is the same as the lowly TD6  .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

As i am new to all this as it is my 1st FFRR use to have a 4x4 sorento, i have yet to find the OBD connector on my RR, and fighting the seller to do his bit with a few other defects

Joe90

The guy in the states tells me the all comms only talks to the BMW RR and not the 2008 Ford one's have you tried any 08 cars with your all comms, if so will you let me know.

Hi philmc79

As far I know he is right, works only for the '02-'05 BMW canbus vehicles.See here:

http://www.rswsolutions.com/index.php?opti...;Itemid=81

It is a 20 minute job with the right tool to sort out the ride height, so the people you bought it off, if they say there is nothing wrong, show them the datasheet and the measurements you have made. If it is meant to be 483mm +/- 2mm and it is 40mmm out, then there is something wrong!

OBD port is above the bonnet release catch / below the light switch on the Driver's side (RHD) .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Thanks for the info i will keep you up to speed on the out come and the new software from RSW

Ride height might be the same as a TD6 but the struts and arbs certainly differ  
07 Supercharged - Still breaking her in!

Boot soundproofing part 1 - http://www.fullfatrr.com/forum/topic15612.html
Custom exhaust - http://www.fullfatrr.com/forum/topic15296.html
18" wheels for Brembo equipped cars - http://www.fullfatrr.com/forum/topic15052.html