Hi all!

My L322 has exterior design pack bumpers front and rear. After checking VIN, I don’t believe they are factory-fitted.

One piece of trim (and same on other side) doesn’t appear to sit flush, and I can’t see how to click it back into place. Can anybody help? See pictured.

Also, I’m not the biggest fan of the exterior design pack in general… so if anybody fancies a swap for a standard Santorini black bumper set in future, I’m in the Stoke on Trent area and would be up for it!

Tom

Click image to enlarge

This is not a helpful reply but…

Welcome to the club - if you find a fix let me know!

I can make it better by taking the bolt off the exhaust trims at the top and free moving it Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF

Thanks for the reply, Dan.

Yes, I’m going to remove those bolts this coming weekend and see what kind of adjustment I get. Might need to cut some new holes to make it fit properly.

Tom

Thinking back I think if you lower the back of the trim(as in the bit toward the front of the car) it goes closer in but then it’s mover obvious it’s hanging low from the side… bad design imho Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF