Hi,

Need to swap mine out again and I cannot find anywhere than confirm the parts numbers required as there seem to be a few options.

Mine is a SWB March 2017 car (with facelift screen etc).

Advanced factors mentions bright/dark finish as a difference but I had these swapped out with some rubbish quality ones so do not have the originals to compare them to.

Anyone got an EPC tell me the correct ones?

This one works

https://parts.jaguarlandroverclassic.com/p...and-rover/

They seem to all come back to the same part number, have a click through, ones with ACE seem to have the same as the non ace cars. But are handed L and R. There is nothing that can't be fixed with a hammer😜😜
FFRR 4.4 SDV8 Autobiography Santorini Black.
KIA E-Niro 4+
2021 Discovery 5 D300 MHEV commercial

Part numbers in this link https://www.fullfatrr.com/forum/post671902.html 2016 5.0 Loire Blue
2002 4.4 v8 Adriatic Blue

Thanks both, I was able to verify the numbers on JLR classic. Haven't used that site in a while and finding L405 stuff on there wasn't straightforward as there used to be no navigation but you could locate via PN.

Also I wanted to verify by VIN range the correct numbers, so I was aware of the old thread but had issues with the stuff fitted so wanted to be 110% sure of the fitment.

If anyone is reading this in future the correct numbers are (for VIN Range: TO VINFA999999 FROM VINEA000001)

LH - LR166064
RH - LR048093

With the dynamic response system, how hard is it to change out the rear/any DIY’s or write ups? Parts are coming in Monday to do mine, as I have a horrific creak like an old mattress when driving with the slightest bit of articulation. Hoping it is the bushings, but being I have a 2017 figured they were due anyway and a good place to start.

Thank you.

Rear bushes are easy, fronts are a PITA as the support bracket has to come off and the bolts for these may strip the threads on refitting.
https://www.fullfatrr.com/forum/topic71328.html
https://www.fullfatrr.com/forum/topic67721.html

My indie is doing mine, one thing I do know from the procedure is to clean up the surface for the D bushes very well as this can cause creaking (your creak is likely from excessive movement tho!)