Whilst I am not a pioneer, thought I post a few photos from my light bar installation. Has turned out to be a very elegant and discreet spotlight solution.

I used a Blackoak 30 inch curved LED bar which amazingly lines up perfectly with two of the bumper bolts. It's depth is also perfect to sit snugly behind the grille.

Was happy to do the mounting myself but took it to an auto electrician with Range Rover experience to wire it up.

That’s a very neat installation. Looks like a perfect solution to the poor output of the pre-2018 lights without spoiling the looks. 2019 L405 SDV8 Autobiography
2023 Defender P400e HSE X-dynamic - gone
2020 Defender P300 SE - gone

2019 Jaguar F-Pace SVR - gone
2013 SDV8 Autobiography - gone
2011 L322 TDV8 Vogue SE - gone
2006 L322 3.6 Vogue Se - gone
1999 P38 4.0 se - gone
199? Classic 3.5 - gone

Very similar to my install… I’m working on a can-bus relay solution atm to allow it to only come on at a pre programmed speed! So say above 40 or 50mph so your not dazzling other drivers unnecessarily at slow speeds… 👍

Hi Craig,

You wouldnt have a list of CAN messages would you  2019 L405 SV Autobiography

I’ll be able to get it I’m sure sir… Not my department, but yes it will have to be decoded if not done already?

Hi, that would be fab, something I have been after for years! 2019 L405 SV Autobiography

That looks a great fit in that space. Do you feel the grill affects the light pattern as is you see darker parts cause its blocked, or is it all quite even? V8 or else ...

Light distribution is quite even. No grille pattern is projected as far as I can tell.

Probably helps that it's a double row light bar. The center section is spot with a 15 degree vertical spread and the sides are flood with a 45 degree vertical spread