Hi all trying to trace an annoying brake pad lowvwarning on dash. L322 2006 6a chasis with td6 engine. Have dissconnected both front and back new sensors and hot wired and fault still occurs. I'm guessing must be a problem with loom can anyone fwd me wire diagram and or shed any light on where the fault may lie.

Does the warning light manage low brake fluid too ? Paul,
2001 Discovery 2 TD5, 211,000 miles & climbing
2006 FFRR TDV8 Vogue 145,000 miles & climbing
Member of Midland (Land) Rover Owners Club, www.mroc.co.uk

I just got a warning saying the pads are low, I checked them recently, they looked ok RR 2005 4.4 petrol
Any spelling mistakes are the fault of spellchecker
Previous MG J2, CITROEN light 15 x 2 gone unfortunately
Present MERC 180e, RANGE ROVER L322, JAGUAR XJS, MERC 280SE, MG F, JAGUAR S-Type 6v 2003, jaguar s-type 8v 2004, Ford Cougar

I take it you have cleared the codes with a diags box once hot wired? I’m pretty sure even on the older ones once the code has been recorded you have to reset the ECU to make the warning light go out.

OK so have removed both sensors and looped over. Cleared fault with gap iid tool and reset by removing fuse. But fault still there. I guess the next stage is to remove cluster from dash and use multi meter back to sensor harness. But before I do I was hoping one of you lot might have wire diagramshowing dash cluster pin ident. I have 2007 to 2012 manual but not 2006.