Hello is there any way how to reset/set easy entry exit function? Mine is working only with steering wheel lifting, but seats doesnt move a bit (i am not at lowest position for sure)

- electric. positioning is function on both seats so no problem here

thank you

I don’t believe the seat moves, only the steering wheel.

The seat moves if the user of the other car key sets it to a different memory position.

 2011 Range Rover Vogue SE 4.4 TDV8

Previous cars :
2003 Range Rover Vogue TD6
1999 Discovery Td5 ES
1995 BMW M5 3.8 6 speed
1992 Range Rover 3.9 Efi Vogue
1992 BMW M5 3.8
1988 BMW 735i SE
1989 Ford Sierra XR4x4 2.9i
1981 Ford Fiesta Supersport

mine seats moving before everytime with steering wheel to the lowest position ... is it possible that this has been coded before?

i was at service with daylight running lights coding (no success ) so they must reboot or recode ECU and after that only steering wheel moving

Why don't you back track and reverse any CCF changes and see if the easy entry seat movement comes back... Then try CCF's again one by one...

If your playing with an IID then there is the "revert to factory CCF configuration" and start again

'cause i have no IID tool (thats why i've been at service with DRL coding ...)

With the key in and ignition on set the seat and wheel to where you want it, then press the M button on the side of the seat followed by one of the numbers 1, 2 or 3. Then when you use your key the seat and wheel should move to the set position. Easy entry/exit only moves the wheel up to the max height when you turn ign off and down to set height when you turn it on. Previously a 2008MY Tonga Green Vogue SE 3.6 TDV8

i know i know ... but i am 100% sure that with Easy e/e it moves with steering wheel to highest and seat to lowest position, but after some coding/flashing my ECU due to DRL it only moves with steering wheel now .. if its not a standard option i will ask them to check for this in my backup ECU file

thank you

My understanding is, that if you are using the same key with easy entry programmed as per Nick591, only the wheel moves. If another key is used, which is programmed to another memory and it is different from the last key used then tbe seats will move to the memory position.

If you have two keys you could check if that is the case John
2008 Stornoway Grey 3.6 Tdv8 Vogue
2005 TD6 Java Black Vogue - Written off!!
GAP iiD BT
2003 Discovery TD5 Auto, Nanocom Evolution - gone to a new home!
MasseyFerguson 152 - No electronics!! - Sold

Weegie good point, but iam using only one key since i bought that car but will try just to be sure ...

as far as i know easy entry should move driver's seat to lowest position - as i am not a very tall man and having my seat quite high i want that function back because i dont want to wear off my seat quicker

Both my wheel and seat move. I only use one key.

Both my seat and wheel move on both keys. 2010 TDV8 3.6 Galway Green

sergeiicz wrote:

'cause i have no IID tool (thats why i've been at service with DRL coding ...)

yeah, they told me as there was an error with downloading DRL "function" to my ECU it should be some glitch too, will see after i manage to get there

- just a quick update -

did a seat calibration via SDD, set one position to memory and now works both fine

Glad you got it sorted sir...