Advertise on fullfatrr.com »

Home > In Car Electronics (L405) > Fitting Dash Cam
Post Reply  Down to end
Page 1 of 4 1234>
Print this entire topic · 
Hairy Dan



Member Since: 22 Jul 2017
Location: NW Durham
Posts: 177

United Kingdom 2014 Range Rover Vogue SE SDV8 Luxor
Fitting Dash Cam

With information from Alistair in this thread http://www.fullfatrr.com/forum/topic30917.html

I decided to tackle the install of my dashcam in the L405

I fitted the dashcam on the n/s of the rear view mirror



I ran the wire up along the headlining and down the inside of the A pillar trim, just pop the airbag badge out and there is a fixing bolt behind, you will need a 6mm spanner

Click image to enlarge


I fastened the wire to the cables which run down there making sure not to place it in front of the airbag which runs down there.

Click image to enlarge


Click image to enlarge


By lowering the lower glovebox and removing the dash end panel

Click image to enlarge


Click image to enlarge


You can feed the power cable down towards the fuse box. If you note the large dash mounting screw in the photo, this is the one I used as an earth.

Click image to enlarge


It's quite a large bolt so you need a ring terminal with an 8mm hole.

I used an 'add-a-fuse' on the positive terminal and plugged that into the fuse for the auxiliary power socket-cubby box which I think was fuse 52.



and that's about it, it works and switches off when the ignition switches off which is how I wanted it, so popped all the panels back on and clicked the glovebox up into position and that was it. Cheers Ian
--------------------
Kielder 4x4 Safari

Post #489038 16th Sep 2018 6:19pm
View user's profile Send private message View poster's gallery Reply with quote
Charles89



Member Since: 11 Nov 2018
Location: Leicester
Posts: 268

United Kingdom 2014 Range Rover SVAutobiography SDV8 Scotia Grey

Good job nice install Thumbs Up

How come no-one seems to wire it into the overhead console? I wired my l322 in to the overhead, and my Audi S8, and I am thinking to do my L405 today into the overhead any clues on the best cable to tap into?

Post #497297 2nd Dec 2018 8:15am
View user's profile Send private message View poster's gallery Reply with quote
stu1



Member Since: 06 Dec 2013
Location: UK
Posts: 276

United Kingdom 2007 Range Rover Supercharged 4.2 SC V8 Java Black

I wired ours into the rear fuse box - really easy, nothing to unscrew. Straight across the headlining on the right hand side and then down the C pillar into the fuse box.

Post #497305 2nd Dec 2018 10:26am
View user's profile Send private message View poster's gallery Reply with quote
Hairy Dan



Member Since: 22 Jul 2017
Location: NW Durham
Posts: 177

United Kingdom 2014 Range Rover Vogue SE SDV8 Luxor

One of the reasons I ran my wire down to the fuse box was because I didn't want to tap into a wire up there and I wouldn't have known which wire to use. However, running it down to the fusebox took an extra 10 minutes and that was the way I had done it on my previous D4's Thumbs Up Cheers Ian
--------------------
Kielder 4x4 Safari

Post #497314 2nd Dec 2018 11:42am
View user's profile Send private message View poster's gallery Reply with quote
Nooney787



Member Since: 17 Dec 2018
Location: Lincoln
Posts: 26

United Kingdom 

Great ‘how to’ Hairy Dan! One question though; how does the A pillar trim actually come off? I’ve removed the ‘airbag’ tag, taken out the bolt and the door seal but this only succeeds loosening the trim a bit - are there any clips or a particular direction to pull in? I don’t want to break anything (or set the airbag off!!).

Post #512624 19th Apr 2019 8:40pm
View user's profile Send private message View poster's gallery Reply with quote
Hairy Dan



Member Since: 22 Jul 2017
Location: NW Durham
Posts: 177

United Kingdom 2014 Range Rover Vogue SE SDV8 Luxor

I seem to remember once the screw is out and the door seal pulled away I pulled the top out first and levered it down as there is part of the lower that slots down between the screen and the dash. As far as I can remember there aren't any other fastenings or clips apart from the screw Thumbs Up Cheers Ian
--------------------
Kielder 4x4 Safari

Post #512626 19th Apr 2019 9:02pm
View user's profile Send private message View poster's gallery Reply with quote
fin



Member Since: 20 Oct 2010
Location: South East London
Posts: 51

United Kingdom 2013 Range Rover Autobiography SDV8 Causeway Grey

One thing to consider if someone is using this as a guide, is if your unit has GPS for speed cameras etc. Before you pick the final place and stick it in (with the worlds most stickiest 3m tape) trial it in a few places as I found (the hard way) that when I took my unit out the L322 and put into the L405 the screen/car is much more difficult to get a decent GPS signal

Post #512735 21st Apr 2019 2:45pm
View user's profile Send private message View poster's gallery Reply with quote
northernmonkeyjones



Member Since: 24 Mar 2012
Location: derby
Posts: 8523

United Kingdom 2016 Range Rover Autobiography SDV8 Santorini Black

Just found this.

Basically exactly the same way is I did it in my 322, except I just pulled back the door seal velvet and tucked the cable down to the fuse box.

I need to do this on my new one when it arrives so good to know everything will go in the same.

I will have to have a look at the fuse box to get an idea of where that fuse is, bottom Right?? There is nothing that can't be fixed with a hammer😜😜
FFRR 4.4 SDV8 Autobiography Santorini Black.
Fiat 500x 1.4 multiair Lounge 2015
2010 LR D4 Commercial 2.7 TDV6

Post #544792 22nd Feb 2020 12:17pm
View user's profile Send private message View poster's gallery Reply with quote
millerj90



Member Since: 25 Oct 2010
Location: Melksham
Posts: 334

United Kingdom 2016 Range Rover Autobiography SDV8 Loire Blue

@Fin
Do you have photo of the position of your front camera that gave you the best GPS signal? I’ve been sitting in the car holding up the camera without any luck so far.

Many thanks.

Post #558264 19th Jun 2020 2:41pm
View user's profile Send private message View poster's gallery Reply with quote
stan
Site Moderator


Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35329

United Kingdom 

have you moved the FF to a different location or even turned it round on the drive... ... - .- -.




Y. O. L. O.
.

Post #558267 19th Jun 2020 2:59pm
View user's profile Send private message View poster's gallery Reply with quote
millerj90



Member Since: 25 Oct 2010
Location: Melksham
Posts: 334

United Kingdom 2016 Range Rover Autobiography SDV8 Loire Blue

@Stan - I spent most of the afternoon trying different positions on the windscreen. I managed to grab a signal once, but couldn’t reproduce it. Didn’t think about turning the vehicle around, great idea, think I’ll go and try that now.

Post #558272 19th Jun 2020 3:42pm
View user's profile Send private message View poster's gallery Reply with quote
Not a Harley Rider



Member Since: 28 May 2020
Location: England
Posts: 9

United Kingdom 2014 Range Rover Vogue TDV6 Corris Grey

Nooney787 wrote:
Great ‘how to’ Hairy Dan! One question though; how does the A pillar trim actually come off? I’ve removed the ‘airbag’ tag, taken out the bolt and the door seal but this only succeeds loosening the trim a bit - are there any clips or a particular direction to pull in? I don’t want to break anything (or set the airbag off!!).


Brilliant how-to, thank you just hard wired mine. I had the same issue as "Nooney" in that the A pillar trim refused to budge (I have been known to be too cack handed so I backed off) a curved wire coat hangar enabled me to feed the cable up into the A pillar.

I have the NextBase camera & found this kit on Amazon, although it arrived with a full size add-a-fuse (I had already ordered a mini add-a-fuse.

https://www.amazon.co.uk/gp/product/B07L59...&psc=1

Post #558716 23rd Jun 2020 11:55am
View user's profile Send private message View poster's gallery Reply with quote
Haylands



Member Since: 04 Mar 2014
Location: East Yorkshire
Posts: 8235

England 2014 Range Rover Autobiography SDV8 Loire Blue

millerj90 wrote:
@Fin
Do you have photo of the position of your front camera that gave you the best GPS signal? I’ve been sitting in the car holding up the camera without any luck so far.

Many thanks.


Won't the heat reflective windscreen prevent the GPS from getting a signal..?? Pete
__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Parchment over Navy Interior. Sold
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand, Jet Interior. Sold
2002 L322 Vogue 4.4 V8 Epson Green, Ivory over Aspen Interior (Fatty Offroader) Sold
-Click for Project Fatty off roader-

Post #558722 23rd Jun 2020 12:39pm
View user's profile Send private message View poster's gallery Reply with quote
millerj90



Member Since: 25 Oct 2010
Location: Melksham
Posts: 334

United Kingdom 2016 Range Rover Autobiography SDV8 Loire Blue

@Haylands - Pete, that is the problem I’m trying to prevent. I positioned the camera in the same place as I had it in my L322, which had the heated screen and sun reflective coating (as far as I know) and it was fine. I’m not sure if this L405 has a thicker coating, but I am indeed suffering with a loss of GPS signal.

I have tried relocating the device to the gap in the coating/elements, I think this is there for toll passes, so they don’t suffer the same RF blocking, but still no signal. Fin seemed to have the situation resolved, so I was wondering if he had found the "sweet-spot"

My next step is to get it out into a wide open space and allow it to re-learn/calibrate satellite positions.

Post #558750 23rd Jun 2020 4:53pm
View user's profile Send private message View poster's gallery Reply with quote
Alistair



Member Since: 11 Feb 2011
Location: Peterborough / Bordeaux / Andorra
Posts: 7937

United Kingdom 2013 Range Rover Vogue SE SDV8 Santorini Black

Mines here & seems to work OK - telepeage tag one side, dash cam on the other.

Not sure whether having some of it tucked under the black strip thing helps......


Post #558752 23rd Jun 2020 5:01pm
View user's profile Send private message View poster's gallery Reply with quote
Post Reply  Back to top
Page 1 of 4 1234>
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site