Advertise on fullfatrr.com »

Home > Maintenance & Mods (L322) > Height sensor problem
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
RRAustria



Member Since: 07 Apr 2015
Location: Graz
Posts: 32

Austria 2004 Range Rover HSE Td6 Bonatti Grey
Height sensor problem

I recently got the dreaded "air suspension inactive" warning. Turns out the arm on the rear left sensor was broken. Replaced it with an aftermarket sensor, calibrated the air suspension and cleared the fault ("81 - RL height sensor invalid activity"). Everything seemed fine until I it the motorway. The car lowered itself to the motorway height (-20mm) and shortly after I got the same error again (invalid activity). Cleared the fault and drove on - after a few miles the same thing again which made me think it had something to do with the motorway height.
Out of curiosity I cleared the fault and locked the suspension. No errors but when I was on the motorway again I got the error once more after a minute of driving - even though the suspension was locked! It somehow seems to be a speed related issue? any ideas what to do?

Post #518306 13th Jun 2019 11:49am
View user's profile Send private message View poster's gallery Reply with quote
RRAustria



Member Since: 07 Apr 2015
Location: Graz
Posts: 32

Austria 2004 Range Rover HSE Td6 Bonatti Grey

Still dealing with the issue...
IIDtool also shows 8A - air suspension CAN error (in the ABS ECU). Also sometimes the suspension goes into hard fault and additionally shows rear right height sensor error. Interestingly when I clear the faults in the EAS computer it clears only one code (but shows 2) and after that no codes are shown. Rear right error only comes on when rear left gave an error first.

What to do next? Replace new height sensor again? BCM? Any ideas what to check or should I go to a stealer and have them read the codes?

Post #521992 17th Jul 2019 8:08am
View user's profile Send private message View poster's gallery Reply with quote
stan
Site Moderator


Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35264

United Kingdom 

when you were on the motorway the suspension lowers around 65mph..this action seems to have triggered your problem...check connections/plugs for broken wires or corrosion.. ... - .- -.




Y. O. L. O.
.

Post #521999 17th Jul 2019 9:37am
View user's profile Send private message View poster's gallery Reply with quote
RRAustria



Member Since: 07 Apr 2015
Location: Graz
Posts: 32

Austria 2004 Range Rover HSE Td6 Bonatti Grey

Will do. what puzzles me is that the error seems to be connected to the motorway speed and not the actual height (I get the error regardless of motorway setting - tried -20mm and 0mm drop as well as locked suspension). I was under the impression that the sensor only sends a height signal and speed is determined through the ABS sensors?

Post #522001 17th Jul 2019 10:46am
View user's profile Send private message View poster's gallery Reply with quote
yelnats69



Member Since: 21 Dec 2019
Location: Dymchurch
Posts: 35

United Kingdom 2011 Range Rover Vogue 4.4 V8 Zambezi Silver

Did you solve the problems

Post #540373 12th Jan 2020 10:11pm
View user's profile Send private message View poster's gallery Reply with quote
RRAustria



Member Since: 07 Apr 2015
Location: Graz
Posts: 32

Austria 2004 Range Rover HSE Td6 Bonatti Grey

yes, I switched the sensors from one side to the other and recalibrated everything. Worked fine after that.

Post #540421 13th Jan 2020 10:46am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site