Hi guys I got a problem with my iid tool I used it last about 1 week ago it was going okay. I hooked it up today it shows on the car but I cant use the controls on the steering functions any ideas

This sounds like one to get in touch with GAP about..... .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Is your handbrake on? Is the ignition on 11?

make sure the engine is running, that will ensure the full voltage is getting round the ecu's..

also check the pins on the obd and the iidtool to make sure they are not bent.. ... - .- -.




Y. O. L. O.
.

Cam-Tech-Craig wrote:

Is your handbrake on? Is the ignition on 11?

Your ignition goes to 11? This I need!

JK - thanks for the help, Craig.

Tallsaj,
check the LED on the side of the IIDTool. You should see a series of rapid blinks as it boots up and then, if you press one of the cruise buttons, you should see a solid light as long as you hold the button. This not happening properly is not uncommon. The cause is usually loose pins on the female OBD connector in your RR.
If you don't see the LED light when you press, send us a mail to Support @ our website and Patrick will get some pin repair pics over to you.

Steve 
RRC 2Dr, RRC 4Dr,
P38, and 2 L322s
(wife thinks I'm nuts - prob right, too)