Don't find my fog lights any good in fog, so got thinking to use them as DRL's?

Would this confuse the Police?
How to get them to come on with ignition?
What bulb should I change to?
Stupid idea? .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Joe90, mine have been done since mid 09 and have had no problems from da fuzz or MOT's

Wire them to a five pin relay with a blocking diode between them...

Had a xenon kit in at first but found them too bright (like some buy racer cars) so reverted back to standard bulbs...




Craig

done mine ages ago...drl switch brought of ebay, splice into the headlight wiring for live ignition and headlight feed..

live ignition switches the leds [in fogs] when you turn the engine on and headlight feed switches the drl's off when the headlights are switched on..

i've had no problems with the law or mot and even when going abroad ...

i tried the drl's in the high beam headlights and the high beams in the fogs but decide finally on the fogs..

the unit that i have ..

http://www.ebay.co.uk/itm/260798015020?ssP...1423.l2649

and a cheaper one ...

http://www.ebay.co.uk/itm/230727784057?ssP...1423.l2661

Anyone fancy a mod to their no led headlights to include the angel eyes DRL's..??

OR will they be naf or not possible to fit.?

Linky Ash
------------------------------------------------------
2016 SDV8 AB

Comport u seen these

Click image to enlarge

I did cliffy - not sure I really like them. I do like the look of the angel eyes and I believe the newer Full Fats have them already. Would love to do the front end conversion but not that rich..!  Ash
------------------------------------------------------
2016 SDV8 AB

OK Stan, like the look of the kits. For that price, it's worth a go. What LED bulbs go into the fogs to replace the existing ones?

And do you disconnect from the normal fog light wiring altogether?

Photo how to would be nice

Useful link from Stan's second ebay post http://www.genlabs.co.uk/support/documents/drlr2.pdf .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Comports, have a look at this thread from the RRS site

http://www.rrsport.co.uk/forum/topic23579.html

Could be an option if you're feeling brave/adventurous

@joe..i put 18 smd's leds in , the 21/27 smd's are to large in diameter to go in the fog aperture but ok in the mains..

i cut the fog wiring and connected the wiring from the drl switch...i connected a 50ohm resister to the existing fog wiring to stop the dash errors, i also make sure i dont switch the front fogs on ...

i'll try and get round to doing a video and stick it on youtube..

@stan like this?:
http://www.ebay.co.uk/itm/H7-18-SMD-LED-DA...3cc0ec2a40 .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

that's the ones joe but i didnt pay that much , it was a whgile ago and i think it was about £9 for the two..i brought a spare set as well cos sometimes you get dry joints on the base of them.

Could I just reconnect the "old" bulbs to one of these:

might serve as a useful under bonnet light with the right holder

or where would I find the right type of resistor to fix to the wiring? .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

on one of my projects i did connect some blue lights mounted under the bonnet and that took the error away ....if you want to go the resister route then ebay has them, get the 50ohm ones... ... - .- -.




Y. O. L. O.
.

I think you can do stuff like this with Navcoder.

I know you can set the light control module to do all sorts inc upto 50% power to main beams as drl's........ 2011 Range Rover Vogue SE 4.4 TDV8

Previous cars :
2003 Range Rover Vogue TD6
1999 Discovery Td5 ES
1995 BMW M5 3.8 6 speed
1992 Range Rover 3.9 Efi Vogue
1992 BMW M5 3.8
1988 BMW 735i SE
1989 Ford Sierra XR4x4 2.9i
1981 Ford Fiesta Supersport