Hi all,
Preparing for a tailgate repaint and full polish of my 2009 RR and trying to find new none original lettering in titanium as the rear letters will be removed.

Any advice of where you've been successful or know where others bought the letters? Been searching on the forum and found the below 4 options.

PowerfulUK don't sell them anymore.
SuperTweaks don't allow me to pay with card.
AliExpress has quite wider offering which makes it hard to tell what's good and bad.
Ebay.co.uk similar to AliExpress.

Need some clear pointers to maybe a specific ebay account if anyone has advice

I bought these:

https://www.ebay.co.uk/itm/256477759542

Decent price, all good really.

Do they make a distinction between bonnet and the tailgate? I understand the bonnet letters are curved.

Thanks for the advice!  2009 L322 4.2 Supercharged

Nope, they were both the same - I replaced both bonnet and tailgate.

ballast wrote:

I bought these:

https://www.ebay.co.uk/itm/256477759542

Decent price, all good really.

RangeRov wrote:

Do they make a distinction between bonnet and the tailgate? I understand the bonnet letters are curved.

Thanks for the advice!

You could try here...

https://www.lrparts.net/vehicle/range-rove...g.html?p=2

Is it that the letters you've got are still ok and only being removed due to tailgate repaint?

If that's the case, couldn't you just have them removed, then renew the 3M tape on the back of them and re-attach?

I think Batfink has the right idea - exactly what I did with about £20 of materials (paint and tape) - looks correct and obviously reuses the original parts. What’s not to like

Jon

Yes, the letters are OK. The guy helping me said there's a risk they will brake when he will remove them, I don't think he have done it before.

As I'll do the repaint first, I can ask him to be careful and buy the lettering removal kit and template from powerfulUK for him.

Are there any particular 3M adhesive tape that are used? 2009 L322 4.2 Supercharged

Get him to use a bit of heat (hair dryer or hot water) on them to loosen the glue, then use some dental floss or fishing string behind them to remove them.

Lots of info if you have a look at YouTube

So long as he doesn’t have hands like an ape then there’s not really much chance of breaking them, as already said a little nylon wire or whatever will ensure they come off without much fuss.

I seem to recall using this stuff to reattach;

https://amzn.eu/d/5ZKAKBh

You just have to get rid of all the old tape in the recess of the letters but it’s better than spending £50+ on new ones. You can even get the correct paint mixed up if you can be bothered but so long as you go with a reasonable matching paint they’ll be fine.

It’s fiddly and time consuming but I’d say worth it.

J

Thanks!

Did you recall using 6.35mm or 12.7mm? 2009 L322 4.2 Supercharged

Hi just double checked my Amazon order from 2022 and it was 6.35mm

It fits quite well into the recess on the reverse side of the letters - bit fiddly as you'll need a sharp knife and cut a few small bits for the E and so on but it worked fine and so far they are still stuck to the bonnet - the most important thing to do is to make sure that the bonnet is squeaky clean before trying to attach.

J