Recently I took out the single back seat when I went on holidays to give me a bit of room.

When i went to put it back in the metal clip( on the base) that holds it to the floor has closed and I dont know how to release it so that the seat will sit properly.

Also the double seat back wont go up from being in the folded position,it will go back a bit but then it wont go any further.
Any clues regarding both problems greatly appreciated.

TIA
littlecub

If your single seat is fixed down at the front as it should be, perhaps try operating the lever which allows you to tilt the seat back forward. I think that would release the catch that is closed, or allow you to fiddle it open. You may have to fold the seat fully flat or even stow competely then move back to as it should be. Cheers
Richard

(there are no such things as an ordinary FullFat, an ordinary cat or too many tools)
2011 TDV8 Vogue Santorini Black
Gap IIDBT

Got the single seat sorted, now to get the double seat back in the upright position.

It will go up about 1/4 of the way then it gets blocked.

Any ideas greatly welcomed.

littlecub

These might help:

TIP: Rear seats won't fold back up?

60-side of 60/40 rear seat stuck folded down .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999