Decided to fit a tow bar myself. Got a good quality bar and dedicated electrics.

Got all the gubbins out of the boot, rear bumper off so far all going well. Put plenty of WD40 on the four bolts holding the two brackets under the car and went off for a cuppa to let the WD40 do its magic.

First bolt a little pressure no problem, loosened it off a few turns, second bolt the same, third bolt put a little pressure on it and bang it sheared off . It sheared so easily that I can only think a previous owner has made an attempt at it before and realised that he couldn't shift and gave up.

I guess all I can do now is take it to a garage and see if they can drill the bolt shaft out and re-thread the hole

Anyone else had this problem?

Unfortunately thats about all you can do. You could attempt it at home but as a safety critical part its probably best left to the pros👍 There is nothing that can't be fixed with a hammer😜😜
FFRR 4.4 SDV8 Autobiography Santorini Black.
Fiat 500x 1.4 multiair Lounge 2015
2010 LR D4 Commercial 2.7 TDV6

Useful vids on extracting sheared bolts





 .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Thanks for that fellas.

All sorted despite the so called experts sucking air and shaking heads . Just needed a little ingenuity and perseverance.

Where theres a will theres a way.