I recently had a rear end shunt – now full repaired by an authorise LandRover dealer – but im sure that the car is sitting a little lower at the rear. I don’t think there is a problem with the repair, I’m thinking the suspension hasn’t been reset. Is there a way to reset this? I recall having an issue once when I changed a wheel and the suspension locked at an unusual height. Any ideas? L405 S/C Autobiog

They naturally sit that way. Maybe your just being more critical now after the repair. Do you have any lights on the height display? Take it back to LR they will reset it or re-calibrate it to the correc heights. [img]http://www.fuelly.com/driver/rob2529/range-rover[img/]
04, 4.4V8, Vogue Oslo Blue with LPG.
"You can sleep in your car, BUT you can't race your house!!!!"

If something can't be fixed with a hammer....... You have yourself an electrical fault!

The 2007 should sit pretty level compared to the older cars that did sit down a bit at the back....

Measure from centre of wheel to bottom of wing on front and back and on both sides and report back.

Should be:

493 front +/- 2mm
483 back +/- 2mm

Although a little more variation is not unacceptable. .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999