When I first got my full fat it was Sitting low at the rear so I had it Re calibrated and it looked 10 times better, couple of weeks later and the suspension compressor failed, my Indy fit a new one and when I got it back it wasn't sitting right, it's just been back in today for them to re calibrate it again and iv just picked it up and it's sitting too low on all 4 corners now by about 1-2cm, it looks crap but the Indy just says they have recalibrated it and that's it, it's actually enough for me to sell it as I'm spending lots of money getting it right but things like this happen! Rant over, anybody able to recalibrate suspension properly on the north east?

There must be a factory setting for the normal height. Either they have set it correctly or they have not? Previously..
Vogue SE TD6
Defender 90 2.4
Defender 110 TD5
Vogue 3.5 EFI

My LR Indy ask me what height I want it. They can set it wherever I want....

I just want he factory setting for 20" wheels, I'll post up the measurements later

buy an IIDTool and do it yourself..  ... - .- -.




Y. O. L. O.
.

Does anybody know where the graph is that shows all the factory height, iv searched but came find it, seen it loads of times, my height at the minute are as follows on 20" wheels

NSF 744mm
OSF 732mm
NSR 722mm
OSR 727mm

So as you can see they are quite far out, I don't know what they are playing at!!! Lol

Off the top of my head I think it's supposed to be about 757mm for the front and 747mm for the rear

its in joe90 gallery i think ... - .- -.




Y. O. L. O.
.

Just went through 56 pages, don't think it's in joe90's gallery lol, I'll keep looking

http://www.roverparts.com/Instructions/L322SRK-C_Instructions.cfm

Lol, I want the air suspension, I just want it at the correct height before my head explodes! Iv seen the table loads of times fo the correct settings but can't for the life of me find it now

found it,

http://www.fullfatrr.com/forum/topic12292....on+heights ... - .- -.




Y. O. L. O.
.

Thank you kind sir, so it seems it is supposed to be 767mm and 757mm respectively, so how can my Indy say they have it correct? I assume this table shows the factory settings, anyway this is how far out it is

NSF minus 2.3 cm (23mm)
OSF minus 3.5cm (35mm)
NSR minus 3.5cm (35mm)
OSR minus 3.0cm (30mm)

I really don't want to ring them again but this is totally un acceptable and I might aswell buy a lowered saxo, I know 3cm doesn't sound a lot but its a huge amount when it comes to suspension, it looks

I lowered mine by 10mm all round.

I was told anything more than that is a big no no.

I lowered mine by 10mm all round.

I was told anything more than that is a big no no.