Guys,
My ID11Tool says that both the front and rear right hand ultrasonic sensors have a fault and in fact none of the sensors activate (click) when i wave my hand in front of them. Do I need to take the bumpers off to have a look at the sensors or should I look elsewhere first?
If I do have to take the bumpers off is it a big job - any hints and tips?
Geoff Geoff

here ya go a good utube vid i used

http://youtu.be/w5-rxKQ49qY

Thanks mate,
That looks simple enough - seen anything similar for the front? Geoff

ill have a look

That's interesting, looks dead easy - I have seen other instructions which bang on about aq load of bolts under the carpet/trim INSIDE the boot which have to be removed

The video for the front bumper was more pushing on a cover - not removing, So I guess there is more to it, obviously it might be possible to access the sensors without removing it which would be good  Geoff