So i stupidly left my driver's window down in a rainstorm, and filled the driver's door control module with water. This meant i had the following issues

Window wouldn't close
door wouldn't lock or unlock with remote or button in centre
mirror wouldn't fold

I ordered a replacement with identical numbers on. Fitted it and now window goes up and down, but drivers side rear door doesn't lock neither does drives door and the car beeps upon locking to say door is open. Replaced module with another one and still have the same issues.

Upon discovering this i took my original apart and cleaned all the corrosion up on the board and reinstalled it. This fixed the window working but in now only goes down by 2 inches before you need to press switch again and then goes down another 2 inches, but drivers door mirror doesnt fold and door wont lock

Do the new replacement modules need to be programmed to the car if so how do i do this i have a IID tool

Many thanks in advance

I'm sorry i don't the answer to your question

If it were me i would just fit it and i'm sure everything will work.

Someone will chime in to help you out.  2003 RR L322 4.4 ltr Auto Zambezi silver Custom paint

Possibly water in the connectors or door lock?

After you fit one, try a battery disconnection, this may help to sort it, I had the window drop 2" at a time issue and it sorted that...

Then, as the manual says.....

Once the power supply is restored, reset the windows as follows:

Close the window fully.

Release the switch, then lift it to the close position. Hold for 2 seconds.

Release the switch.

Repeat the lift and release procedure twice more. (first time usually does the job)

Test the window for correct manual and automatic switch operation.

Repeat the procedure on each window. Pete
__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Parchment over Navy Interior. Sold
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand, Jet Interior. Sold
2002 L322 Vogue 4.4 V8 Epson Green, Ivory over Aspen Interior (Fatty Offroader) Sold
-Click for Project Fatty off roader-

On my car 2012 TDV8 when the modules have been reset or power disconnected I have to use the GAP tool to re program the windows.

There is the option in calibration for the drivers window, when you run it it first does both the windows on one side, down and up then it does the other side.

give that a try and see if it resolves your issue. 2012 TDV8 Autobiography Baltic Blue
Previous
2007 BMW M5 E60

cheers, i ve not had a lot of chance to look as my son was diagnosed with Leukemia, so been running him forward and back to hospital, but hopefully will get 5 to look soon

Sorry to hear about your Son, hope his treatment isn't too hard on him and he gets some real benefit from it! 2003 RR L322 4.4 ltr Auto Zambezi silver Custom paint