Advertise on fullfatrr.com »

Home > Technical (L322) > Engine System Fault after split intercooler hose
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
rich89



Member Since: 05 May 2013
Location: United Kingdom
Posts: 295

United Kingdom 2010 Range Rover Autobiography 5.0 SC V8 Causeway Grey
Engine System Fault after split intercooler hose

Hi All,

After 5 months of trouble free motoring (2006 3.6 TDV8 Vogue) I had the engine system fault pop up with limited performance.
Turned out the top right hand intercooler hose had a split in it.

I replaced it and all was good for a week or so (Very few miles driven).
I was on my way home this morning and it popped up again. Checked the hose and its seated correctly and not split again so i'm unsure why it's done it again.

My cheapy little code reader displayed this:
P123B
Barometric Pressure - Turbocharger/supercharger boost correlation sensor B.

Me not knowing anything about turbos/boost, has anyone has this before?

(I tried to clear the code but it did not clear)

Thanks

Post #604077 18th Aug 2021 11:19am
View user's profile Send private message View poster's gallery Reply with quote
stan
Site Moderator


Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35267

United Kingdom 

if that hose went it might be that another is on the way out.. ... - .- -.




Y. O. L. O.
.

Post #604087 18th Aug 2021 12:41pm
View user's profile Send private message View poster's gallery Reply with quote
rich89



Member Since: 05 May 2013
Location: United Kingdom
Posts: 295

United Kingdom 2010 Range Rover Autobiography 5.0 SC V8 Causeway Grey

I'll go and check the others later.

Post #604093 18th Aug 2021 1:48pm
View user's profile Send private message View poster's gallery Reply with quote
William97841



Member Since: 18 Jan 2015
Location: Essex
Posts: 141

United Kingdom 2007 Range Rover Vogue SE TDV8 Stornoway Grey

If your getting black smoke it might be the inlet manifold check for cracks normally along the top seam. Hope it helps.

Post #604423 22nd Aug 2021 7:57am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site