| Air suspension pointers needed please | |
Hi guys, help needed please, I've had a adaptive dynamics fault message ping up on the dash (
60 plate autobiography), so i checked the obvious, the sensor on the drivers side wire had split, no issues, replaced with a repair kit and all good, however i've had it scanned as the message didn't clear and the code was C1A20-64. I've looked at the workshop manual and it gives the following info : Pressure Increase Too Slow When Filling Reservoir - Signal plausibility failure
Signal plausibility failure
Gallery pipe air leak
Compressor fault
Reservoir pipe air leak
Reservoir air leak
Intake filter
blocked/restricted
Intake pipe
blocked/restricted
Air suspension intake
silencer blocked/restricted
Corner valve stuck open
So I'm now a bit stuck as the off road height works and the compressor lifts it up no problems without any sag overnight so i'm guessing no air leak but i haven't checked properly yet. Has anyone had this problem before or know where or how to start checking any possible faults, thanks in advance and sorry for the long post!!
|
28th Mar 2021 1:31pm
