Just got car back from repairers after a rear end shunt. Foolishly only checked rear bodywork didn't think to start it up. Got in after delivery wagon had left and on start up it flashed "select neutral" and then when I tried to reverse out it flashed "slow down". Immediately thought of Low Ratio settings and tested selecting low ratio box. The switch does nothing. I select low ratio regularly so that was a surprise. Put IID Tool on: no faults stored. Turned off and started car again - exactly the same messages again. Wondering if driver tried low ratio to get on transporter and has ' up' something. I am waiting for call back from repair garage. Any ideas on what it might be? Wondered about a fuse?

Is it fuse 37 that has to be in to force transfer box neutral?

Ie you need to remove the fuse to drive normally ? 2011 Range Rover Vogue SE 4.4 TDV8

Previous cars :
2003 Range Rover Vogue TD6
1999 Discovery Td5 ES
1995 BMW M5 3.8 6 speed
1992 Range Rover 3.9 Efi Vogue
1992 BMW M5 3.8
1988 BMW 735i SE
1989 Ford Sierra XR4x4 2.9i
1981 Ford Fiesta Supersport

It is....

Not sure if the message on the instrument cluster is what you have though.

Hope you get it sorted.