Hi All

I have just purchased a genuine replacement rear wiper arm from land rover part LR012046 and i have just come to fit it and it doesn't have any splines in the hole where as the old arm has splines and so does the motor. Can anyone advise if this is correct or i have a faulty part?

Matt

seems to be the correct part number , does the spline bit in the old arm come out and then fit into the new arm.. ... - .- -.




Y. O. L. O.
.

no its not a removable part its cast as part of the old arm

Matt

i've googled that part number and loads have it specified for the l322, maybe ducky Dan could enlighten the situation but he's probably off till monday.. ... - .- -.




Y. O. L. O.
.

There were no splines on mine when I replaced it. The arm is cast aluminium, and I figured that the splines on the shaft imprinted onto the old arm. I haven't had any problems so far

I don't think they have splines. I think the taper and the nut create the splines in the wiper arm. That way if anything stops the motor the sacaficial bit is the wiper arm. [img]http://www.fuelly.com/driver/rob2529/range-rover[img/]
04, 4.4V8, Vogue Oslo Blue with LPG.
"You can sleep in your car, BUT you can't race your house!!!!"

If something can't be fixed with a hammer....... You have yourself an electrical fault!

[
]

+1  Stolen / Gone: 2006MY Supercharged LPG Autobiography - Zambezi Silver with Sand/Jet/Jet Oxford Leather.....

Its an imprint made after its fitted...