I'm searching everywhere! I'm trying to find the bezels that the parking sensors sit in, in the front bumper
2003 vogue

I can't seem to find them anywhere

Any ideas?? Or anyone might have a couple? I'm after the two centre ones in java black preferably 

It's taken hours but iv finally found them!

If any one else is interested in the future.
The bezels around the parking sensor that hold it into the bumper come in sets of 4

The fronts are VUB503800LML
And the rears are VUB503810LML

£24 +vat from duckworths 

thanks for the headsup Deasy..  ... - .- -.




Y. O. L. O.
.

These the parking sensor holders that they clip into?

Yes mate they are 

I was quoted £13+VAT each other day from Dan. I need to check its correct part.

http://www.duckworthparts.co.uk/landrover/...B503800LML

Maybe he quoted you on an actual sensor? 

Just noticed where parking sensor goes should look like this

Click image to enlarge

Click image to enlarge

Admin note: this post has had its images recovered from a money grabbing photo hosting site and reinstated

@ollielloyd by the looks of your bumper it doesnt look like you missed anything at all

^^^^^  .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

Any helpful feedback?

Does the other (good?) side look the same with sensor removed? If not then the tabs could have been bashed off when the collision (?) took place. If the (good?) is the same as your picture do you have/need a different type of sensor housing? .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999

i dont know how much it would cost to repair that damage, but i swapped out a front bumper off fleabay for £120 (with my writeup on here on how easy that is to do) , this would would also solve you parking sensor problem? 2007 3.0L Diesel VW Touareg SE
2003 4.4 LPG, Vogue, Silver

The two middle bezels clip in, however the two corner ones have a square plate on the back which glues onto the back of the bumper,

Then the sensors clip into the bezels

I got a bumper of eBay for £40, £15 for delivery, £6 for 2 centre bezels, and £10 for a can of java black spray (thank to dan at duckworth) 

Dan isn't aware of any square plates?

Anyone shed any light on this? Once the parking sensor is in its bezel what is needed to keep it in the bumper?

It's the passenger front corner one.

Thanks