Yesterday a big @ss nail got into my rear tire and it deflated quite rapidly (thanks to the TPMS I noticed it before damage could occur to the sidewall). Since my original jack failed dismally shortly after getting the car, luckily not with the full weight on it, I got a Landcruiser jack (or so I was told). And of course that was not sufficient for jacking up the car to lift the tire off the road (in the concrete parking garage so superflat). So now I am looking at getting a 3 ton trolley jack so I won't get caught out again. However what lifting height should I get as a minimum taking into account that it may be on a "bad" surface here. MY 2010 5.0 SC Galway green and sand interior!!
Have the Faultmate MSV2 Extreme to be tinkering with the settings etc. !!

I've done this... It's an amazing jack..

http://www.fullfatrr.com/forum/topic14177....cedes+jack Previously..
Vogue SE TD6
Defender 90 2.4
Defender 110 TD5
Vogue 3.5 EFI

Sounds like the perfect option, but unlikely I can get that here May have to order it via Holland then. MY 2010 5.0 SC Galway green and sand interior!!
Have the Faultmate MSV2 Extreme to be tinkering with the settings etc. !!

You need more bits in your package fella

I got one as per here

http://www.fullfatrr.com/forum/topic14360.html

http://www.ebay.co.uk/itm/HYDRAULIC-BOTTLE...2c6c112cdc

And fitted to the car it looks like this

Click image to enlarge

Hi, I have got a merc sprinter van jack in mine also, Its very good.

It easily extends far enough to pop the wheel off, and is very sturdy, i haven't got round to replacing the top piece with the correct bmw style one, but the merc style one does fit in the sill jacking points slightly diagonally.

I have however heard that it wont fit under the sill if the tire is flat and the suspension has dropped. (but if that is the case ill be getting her recovered)

I've got someone trying to get a Sprinter one here first. Otherwise I will go for a "standard" bottle one and a block of hard wood (easy to get here!) or a small trolley jack (3t). MY 2010 5.0 SC Galway green and sand interior!!
Have the Faultmate MSV2 Extreme to be tinkering with the settings etc. !!

Make sure if you get a trolley the reach is sufficient to lift.

I have a 3t high lift one which seems to work ok, but my 2t doesnt come close. There is nothing that can't be fixed with a hammer😜😜
FFRR 4.4 SDV8 Autobiography Santorini Black.
KIA E-Niro 4+
2021 Discovery 5 D300 MHEV commercial

I use an old Land Rovery Discovery jack & it works a treat, nice & stong, good height & weight ability.  The reason women's minds are cleaner than a mans mind is that women change their minds more often!
When women say fine a mans in deep doodoo as fine has so many meanings.

I noticed a bottle jack in the engine bay of my mates Discovery. Why couldn't they have done this with the FFRR?

Weight and cost saving no doubt. Discovery 4 HSE
1998 110 TUM HS FFR Hard Top XD WOLF
1982 Series 3 Hard Top

*Gone:L462 D5 HSE LUX, L663 Defender 110 HSE, Discovery 3 HSE, 2014MY Range Rover Sport 5.0 Supercharged AB Dynamic; L405 Exec Vogue SE 4.4, 5.0 Supercharged Autobiography, Defender TDCi XS CSW, Defender TD5 HT, Vogue SE TDV8, Vogue TD6, RRSport SC 4.2V8, Classic 3.9 Vogue Auto, Land Rover Series 3 SWB

My Jack …..


Works all the time …


 ====================================

"Open Mike Night " sounded like a lot of fun until i found out i was going to an Autopsy

^^^



...and that's what landrover think as well..... ... - .- -.




Y. O. L. O.
.

The bottle jacks were only fitted to coiled Disco's.

If his was airsprung then he should take it out if it ever goes to visit a dealer as they recalled them for the scissor jacks in those models due to a safety concern  FFRR MY06 facelift With TDV8 Alloys Zeros/ATR's
Mantec Sump Guard, Rigid Load liner, MY10 BT upgrade.

RAC, AA, ADAC, ANWB, AAA etc. don't really operate in Nigeria So one has to find another way Currently the boys are hunting for a bottle jack (Sprinter). MY 2010 5.0 SC Galway green and sand interior!!
Have the Faultmate MSV2 Extreme to be tinkering with the settings etc. !!

I've searched in vain, but I'm sure that I someone mentioned that you could:
- go to off road height
- place an axle stand underneath that corner
- select low height and the wheel then lifts off the ground

doesn't that remove the need for a jack completely?