 |
fullfatrr.com Wiki > FBH Remote Programming |
Revision as of 09:51, 13 May 2011 by Dan uk 1984 (Talk | contribs)
Contents |
Fuel Burning Heater Remote
Programming the Factory / Webasto Remote
- 1. Pull fuse and wait 10 seconds
- 2. Replace fuse
- 3. Press off within 3 seconds
Batteries
2 x 12v Type: MN21
What the manual says
The remote handset transmitter control has a range of approximately 330 ft (100 m) and for optimum performance, should be held vertically when operated. There is no need to point the antenna at the vehicle and avoid touching the antenna when operating the ‘on’ or ‘off’ buttons.
Press the ‘on’ button for 1 to 2 seconds: The indicator light flashes every 2 seconds to confirm that an automatic heating program has been initiated and that the system is operating.
The heating program continues to operate until the ‘off’ button is pressed. After 30 minutes, if the heating program has not been switched off using the remote handset, it will be switched off automatically, to prevent the vehicle battery discharging.
