| Search results - "Nav" |
Nav TV Box secured by sticky velcroBox sits neatly in recess to left of IHU
|
|
Nav TV wiring in situHaving installed wiring back in to recess, the wire was passed over the top of the IHU - and ends in the white plug - Box plugs to this.
|
|
Space on left of IHU for Nav TV unitYou can see the space here on the left of the IHU (underside of wiring controller) against which the Nav TV module can be fixed.
|
|
Nav TV Wiring plugged into IHU wiringSimply plug the ends of the wiring loom supplied in between the two connectors - leaving the white plug for the Nav TV unit
|
|
Nav TV Module and WiringThis is how the unit comes - wiring and module.
|
|
IHU Cables pulled out and disconnectedThe cables (which are normally plugged together) are pulled out from the recess and unplugged
|
|
IHU cables as found under kick panelThis picture was taken just after removal of the kick panel - and the connector can be clearly seen
|
|
Underside of IHUThis is what you see if you manage to stuff your head at an unnatural angle in the passenger footwell... note space on left, and wiring on right.
|
|
All footwell panels cleared out of the wayThis is what you need to get to before sticking your head into the footwell...
|
|
Careful of wire for footwell lampGently unplug this wire to allow removal of kick panel
|
|
Remove Kick PanelThis panel is removed by removal of three screws that are located along the edge of the lower glove box.
|
|
Remove the side panel and wood trim (in this case Black Piano Wood)Remove the screw to the left of the picture, then carefully unclip the rest of the panel. Caution - some force is needed, and the clips are fragile - and can escape at some speed past you through the open doorway (APPARENTLY) ;-)
|
|
| 14 files on 2 page(s) |
 |
1 | |
|
