Hi everyone,

I’ve been searching through the service manuals and on Google to find the torque spec for the appearance cover mounting stud for my ’09 SC Range Rover.

Engine Cover Mount Stud part number KKN500051. Reference numbers 3 and 4 in this image.



The nut to hold the cover on is torqued to 5 Nm but I can’t find anything about the stud itself.

Does anyone have any info on this? I’d hate to over or under torque it.

Thanks!
Larry. 2009 Range Rover L322 Autobiography
Bournville/Ivory
Save lives, give blood.

A member of my local Land Rover group said, in his opinion, 10 Nm would be about right. I took his suggestion and it's now all back together and I managed to not strip any threads!

Larry. 2009 Range Rover L322 Autobiography
Bournville/Ivory
Save lives, give blood.

if its not in the WM then i doubt if anyone would know the torque..

10nm sounds about right.. ... - .- -.




Y. O. L. O.
.

I am tempted to say, for this non mission critical stud, tight enough will be good enough.... .
Experience is the only genuine knowledge, but as time passes, I have forgotten more than I can remember
Volvo V70 P2 2006 2.4 Petrol 170bhp Estate SE
MG Midget Mk1 1962

Previous: L322 Range Rover TDV8 3.6 2008; L322 Range Rover TD6 3.0 2002; P38A Range Rover V8 1999