2008 4.2 SC Gearbox service/sump | |
Hi all,
So I've had my gearbox flushed last year by Bodsy, though it a good idea to change the sump and filter too, so on the recommendation of my LR indy I bought the metal sump kit off eBay, I think it was the Britpart one or at least supplied by them.
I changed the sump for the metal one, it was while I was doing that my LR indy mate mentioned that sometimes the supplied bolts are too long and to use washers under them, at that point I wish I'd chucked the lot in the bin and bought genuine ZF again (the plastic type)
But I didn't, I carried on and used the washers under the bolt heads, all was fine for a while then it started weeping, and has done on and off for a year now, I keep tightening the bolts and checking the level, it stops weeping for a short time, then starts again, so am guessing the gasket is leaking.
I am mechanically competent and have followed the torque sequence and settings.
So, I'm going to do it all again using a genuine ZF sump.
I did the mechatronic seal (using genuine ZF part) so won't be doing that again.
I just wanted to double check myself really, it is a ZF 6HP26 gearbox isn't it?
Has anyone else encountered this problem of the leaking when a metal sump is used?
This is the kit I'll be using this time, am sure this is right but just wanted to double check
https://www.advancedfactors.co.uk/lr007474...0704-p.asp
Thanks in advance for any replies! 2008 L322 4.2 V8 SC Stornoway Grey
2006 L322 4.2 V8 SC Java Black
|