From WS Manual
As different pressure targets and thresholds for the front and rear tires, the Tire Pressure Monitoring System (TPMS)
can identify the location of the tires. The TPMS system then assigns received tire pressure sensor identification to a
specific position on the vehicle. For example: front left.
The TPMS locates the position of the tire automatically. This function requires no manual intervention by the driver.
The TPMS automatically learns the position of tires on the vehicle if the tire pressure sensors or their positions are
changed on the vehicle.
The tire learn and location process is ready to start when the vehicle has been stationary, or is travelling at less than
20 km/h (12.5 mph) for 15 minutes. This is known as 'Parking mode'. The learn/locate process requires the vehicle to
be driven at speeds of more than 20 km/h (12.5 mph) for 15 minutes. If the vehicle speed reduces to below 20 km/h
(12.5 mph), the learn process timer is suspended until the vehicle speed increases to more than 20 km/h (12.5 mph),
after which time the timer is resumed. If the vehicle speed remains below 20 km/h (12.5 mph) for more than 15
minutes, the timer is set to zero and process starts again.
The TPMS can automatically detect, under all operating conditions, the following:
If 1 or more tire pressure sensors have been replaced.
If 1 or more tire pressure sensor identifications are missing.
If 1 or more ‘alien’ identifications are being received (the TPMS will reject these signals).
DESCRIPTION
Identifications from tire pressure sensors that do not belong to the vehicle.
If 1 of the tires in use on the vehicle have exchanged position on the vehicle.
If 1 or more incompatible tire pressure sensors have been installed.
If the tire pressure sensors installed to the running wheels are changed, the TPMS can learn the new sensor
identifications automatically. The learn function requires no manual intervention by the driver.
The RF transmission from the sensor contains a unique identification code in its transmission data, so that the TPMS
can identify the tire on the vehicle. If the sensor is replaced on a ’running’ wheel, the identification for that sensor may
be programmed into the TPMSCM using a Jaguar Land Rover (JLR) approved diagnostic equipment. That wheel is
not monitored until it is programmed, or until the wheel is learned by the vehicle, which can take up to 15 minutes. The
identification code is on a label with the complete wheel and tire assembly when new and is printed on the casing of
each sensor. 2018 SE SDV8 4.4 Byron Blue
|