Advertise on fullfatrr.com »

Home > Technical (L322) > TD6 Aux Belt Change Guide
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
dmcsweeney



Member Since: 22 Feb 2021
Location: Cork
Posts: 2

Ireland 2002 Range Rover HSE Td6 Epsom Green
TD6 Aux Belt Change Guide

Hi all, was completing the engine service on my TD6 last night. Last job was to fit an EGR bypass. I dropped a 10mm socket and short extension into the engine bay, it appeared to land in the under tray. I started it up, and after about 10 seconds a belt started to screech. I shut it off and checked, all seemed fine, fired up, and again nothing for a few seconds. The AC belt had started to strip, long strands of rubber handing off. My belts always chirped from cold but this is worse. I'll drop the tray later and find the tools. Is it possible to change the ac belt without removing the fan, fan shroud etc? Has anyone got a guide to changing all the belts, and idlers etc if required. Everything I could see still appeared to be spinning, but the inner edge of the ac pulley felt a lot warmer than the outside and the inside of the belt was stripping.

Thanks,
Dave

Post #584797 22nd Feb 2021 9:52am
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site