Hi All

Noticed the yellow engine management light illuminate on the dash today all seems well and no noticable changes. only serviced 2 weeks ago

so

i am in the market for a fault code reader, rather than just hand good money over to the garage to plug one in
i have a couple of other cars it would come in handy for too.

Any suggestions or particular ones i should look out for? 2010 defender utility
2010 RRS TDV8 (gone)
2007 discovery 3 (gone)
2004 discovery 4 (gone)
1994 discovery 1
1970 v8 hybrid (gone)
1975 bobtail (gone)

consider a GAP iidtool...although expensive it is the best around... ... - .- -.




Y. O. L. O.
.

I use the AUTEL MD806 PRO, been very good so far with servicing, wind rear callipers back and counter reset, I also traced and repaired airbag faults. Paid about £230 for it and it‘s also compatible with all makes of vehicle.

stan wrote:

consider a GAP iidtool...although expensive it is the best around...

A 16MY is right on the edge of what's covered/compatible Stan... I spoke with Patrick recently and the IID won't programme any CCF's on 17MY's... So, worth checking beforehand sir/s

 ... - .- -.




Y. O. L. O.
.