![]() | Home > In Car Electronics (L322) > Gap tool interpretation |
![]() ![]() |
|
|
alfapat Member Since: 09 Apr 2017 Location: Elgin Posts: 349 ![]() ![]() ![]() |
How can I pinpoint the fault shown on my Gap tool , (Auxilary sensor incorrect)
|
||
![]() |
|
Bushy30 Member Since: 03 Jun 2018 Location: Powys Posts: 1099 ![]() ![]() ![]() |
What's the fault code? Current: 2011 FFRR Vogue SE 4.4 TDV8
|
||
![]() |
|
alfapat Member Since: 09 Apr 2017 Location: Elgin Posts: 349 ![]() ![]() ![]() |
It just says The above in invertered commas.
|
||
![]() |
|
alfapat Member Since: 09 Apr 2017 Location: Elgin Posts: 349 ![]() ![]() ![]() |
Yes I know, this fault returns and will not clear . I am going to bite the bullet and buy a proper battery. Inactive warning comeback today and going through the faults, the front right sensor came back after running the car for four days and clearing the fault. Something not quite right when t thinks that I am at full Hightower and warns me that I shouldn’t be over 30mph , when clearly the suspension remains in normal ride height.
|
||
![]() |
|
Bushy30 Member Since: 03 Jun 2018 Location: Powys Posts: 1099 ![]() ![]() ![]() |
Sounds like the best plan |
||
![]() |
|
alfapat Member Since: 09 Apr 2017 Location: Elgin Posts: 349 ![]() ![]() ![]() |
New battery installed and much as such has happened again ....especially “Auxiliary sense incorrect” so not sure what that could be . |
||
![]() |
|
alfapat Member Since: 09 Apr 2017 Location: Elgin Posts: 349 ![]() ![]() ![]() |
|
||||
![]() |
|
alfapat Member Since: 09 Apr 2017 Location: Elgin Posts: 349 ![]() ![]() ![]() |
Dash clear at the time , switch off everything and up comes suspension inactive as it closes down. |
||
![]() |
|
DrRob Member Since: 16 Apr 2015 Location: Petersfield, Hampshire Posts: 4332 ![]() ![]() ![]() |
Are you near Dundee? Take it to MMP Land Rover aka Disco Mikey on here |
||
![]() |
|
alfapat Member Since: 09 Apr 2017 Location: Elgin Posts: 349 ![]() ![]() ![]() |
No I’m not really, in any case O would always try and resolve this myself.
|
||
![]() |
|
DrRob Member Since: 16 Apr 2015 Location: Petersfield, Hampshire Posts: 4332 ![]() ![]() ![]() |
OK. Hope you get it worked out |
||
![]() |
|
alfapat Member Since: 09 Apr 2017 Location: Elgin Posts: 349 ![]() ![]() ![]() |
That clicking has been resolved which was a stepper motor in the HVAC SYSTEM and quite easily accessed.
|
||
![]() |
|
![]() ![]() |
|
All times are GMT + 1 Hour |
< Previous Topic | Next Topic > |
Posting Rules
|
Site Copyright © 2006-2025 Futuranet Ltd & Martin Lewis
