Granted they need a bracket and belt but this could be had for under £100 if you know what you’re doing item no eBay Item No. 123798031835 Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF

FYI the brackets are very specific for this one as are the seatbelts.

. Cheers, Greg
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
2011 Vogue SE 4.4 with lots of toys in Stornaway

I ended up doing a low ball offer and got them- can the brackets not be fabricated fairly easily? It look like a tube that mounts the back seat? Seat belts I was going to use generic lap belts? Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF

Dan also just to let you know this set up is a 3-point belt. Lap and sash I think they call it. In my pic the vinyl covered bracket is the high mount point for the sash. I wouldn't recommend you fit lap only.
. Cheers, Greg
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
2011 Vogue SE 4.4 with lots of toys in Stornaway

Jut looking t your pic , seat belts aside I am just missing the two brackets to the right of the tape measure - I’m sure they could be fabricated if someone would be kind enough to measure them the upper brackets you mention not pictured are the for the belt of the seat? Seatbelts I think I will have to tap and die and maybe fabricate something for the buckles like yours . Thanks Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF

Look at the the two ebay pix above, There are five pieces (excluding belts).

2 x pieces with protruding rods
These hold the reels , hook into the main rear seat latches, and the rods protrude towards the centre of the car, you will have sockets on the 7-seater seat back (also shown bottom of my bit photo.

2 x pieces flatish with two holes each
These are the upper belt anchors that fit into the headrests, one is also shown in the pic where I vinyl covered it

1 Long piece with two hook ends.
This is for the two belt sockets and the hooks hook onto hooks already in your boot floor under your rear seats. This piece lies flat on the boot floor and the 7-seater seat is on top of this.

. Cheers, Greg
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
2011 Vogue SE 4.4 with lots of toys in Stornaway

This one off ebay shows it pretty well

https://www.ebay.co.uk/itm/range-rover-L32...7675.l2557

I took one of their photos and marked it up:






. Cheers, Greg
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
2011 Vogue SE 4.4 with lots of toys in Stornaway

Thanks - I have checked the laws and safety and I think I’m going to go with lap belts as unless you have a high speed crash in reverse they will pretty much be as efficient and you are the wrong way round. I don’t suppose in that case you would be kind enough to take a couple more close up pics of the two brackets that hold the seats to the back seats with the tubes? Even better would be some measurements I can fabricate some then. Thanks! Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF

if you get rear ended wont whoever is sitting in those seats smash their faces on the rear window..?? ... - .- -.




Y. O. L. O.
.

If they are loose you would but I have sat in the back and even if you are a giant if they are tight there is no way you’d hit the glass unless the hit you so hard the glass came to you but by then you’ve got bigger problems like your legs! Current stable:
2006 BMW M6
2007 4.2 V8 S/C FF
Gone:
2002 4.4 V8 FF