a while back i posted this thread re dynamic/sequential indicators on the audis and how i liked them...
http://www.fullfatrr.com/forum/post451567.html#451567



it seems there are boxes available from china that can be wired up to normal indicators that allow this function..
https://www.ebay.co.uk/itm/2X-3-Step-Seque...2467227418



so, does anyone know whether the rear led lights on the 2010-2012 FF's can be adapted ?

On the 322 the rear indicator only has one bulb, a standard tungsten filament......well mine is as I replaced one a few weeks ago.
As only one bulb there is nothing to “sequence”...... David

Please let me know if my comments upset you, I may wish to upset you again.

hence my ref to 2010-2012 led indicators.....

there are 8 leds in the horizontal plain that can be sequenced...

My bad......I thought all 322 had the single DI lamp, I guess if the LED pcb assembly can be physically rewired you might be able to sequence some how, but it’s only going to be limited to within the small round DI reflector, not sure it’ll be very visible as a sequential system as in the long thin type that Audi/BMW have. David

Please let me know if my comments upset you, I may wish to upset you again.

if you fast forward to 6.12 on this video you will see the 2010-2012 indicators in action...




i think the way to find if this mod is possible is to find/get a broken tail light to experiment on..

Stan, i think they are being worked on at present by Powerfuluk LTD...

May save you some messing about?

thank you craig...i wait in much anticipation...

i dont suppose you have any more info on this Craig?

Was looking at those too - Stan I picked up a 2011 tail light with a broken lens from another member.

If you want we can use as a test unit.

I've taken it apart, the LEDs come out, they are on a plastic flexible track. Kinda like a flexible circuit board.

Sending 12v into the light (off the car, just a straight 12v feed) lights up the LED solid, no flash.
So the flash comes down the line, a normal set up in that respect.



. Cheers, Greg
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
2011 Vogue SE 4.4 with lots of toys in Stornaway

i thought this would tickle your fancy greg


so can the track be split into four bits so the light module could 'light' each in sequence...
the module in my previous post is a 3 way one but i have found a 4 way one on ebay...

I'll get it out, pull out the track and post a pic....
. Cheers, Greg
- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - -
2011 Vogue SE 4.4 with lots of toys in Stornaway

nice one greg..


this is the 4 step module on ebay, strangely its location is in bulgaria....

No more info I'm afraid Stan as i haven't been there for weeks and weeks! Alas been too busy!

If you need any bits to "mess about with" i have a box full of broken bits

Close up of the ribbon cable:

When i made my last set of lights for my 322 i had to get two damaged lights and use the back of them then take two perfectly good lights and cut the back off slowly slowly slowly!!! Until i was left with four halves which i PU glued back together after assembling...