Hi all, I am wondering I've noticed my rear bumper has a little gap, the car hasn't had a bump it seems maybe the clips holding the bumper are broken...I THINK? Is this an easy fix/repair?

The only L322 I owned (and two were from new!!!!) that didn't do this was my 5 litre SC (and it did after they replaced a parking sensor). It's basically thin plastic tabs which eventually wear with movement and - well you can see the end result! Land Rover Addict
XXXXXXXXXXXXXXXXXXXXXXX

Previous
XXXXXXXXXXXXXXXX
2009 5.0V8SC Autobiography
2006 4.2V8SC Autobiography
2004 4.4V8 Vogue

Its tricky to remove the rear bumper without at least some of the retaining slots in the bumper breaking and/or the tabs in the concealed plastic trim they slot into breaking, although once the bumper is removed, this can be replaced by drilling the aluminium rivets out and re-rivetting a new part in.

Best advice from my experience is to gently warm the bumper in this area each side before carefully pulling the bumper outwards, not a good idea to start tugging on it when it's too cold.