Advertise on fullfatrr.com »

Home > General > Goods carrying...
Post Reply  Down to end
Page 1 of 1
Print this entire topic · 
Terrier



Member Since: 17 Dec 2015
Location: Yorkshire
Posts: 51

Goods carrying...

I'm picking up 6, 2.6 x 120 x 250 new oak railway sleepers next week and I fancy using the 2011 full fat for the job. Any advice from any of our FFRR friends in so much as the weight and leaving the tailgate down etc. I've got some lashing straps to secure the load and shall put a red rag on the back. Should let I put a block at the rear to keep weight in the boot area rather than the tailgate?

Any thoughts comments etc much appreciated as I'm a novice, a 48 year old novice!

Post #396288 15th Jul 2016 9:02pm
View user's profile Send private message View poster's gallery Reply with quote
Giantlandyman



Member Since: 25 Nov 2015
Location: Essex
Posts: 800

United Kingdom 2012 Range Rover Autobiography TDV8 Santorini Black

I think the most important factor in this is driving with the tailgate open. Even if it is raining, all windows must be fully open and if you have it, I would tilt the sunroof as well....

One of the reason exhausts must be sealed front to back is because CO is a 'silent' killer. If you've ever been in a convertible car with no wind deflector behind the front seats, you'll have felt the air 'pushing' from behind as it were. With the rear open, there is a high chance for fumes to be 'pushed' inside the vehicle....it's to do with pressure differences, I believe.

As for the load capabilities, I personally wouldn't want to put too much stress on the tailgate...it's not just about strength with a static load because you will be moving and bumps/jolts will make the weight on the tailgate greater, if that makes sense. In my opinion, of course.

Post #396296 15th Jul 2016 9:39pm
View user's profile Send private message View poster's gallery Reply with quote
Alistair



Member Since: 11 Feb 2011
Location: Peterborough / Bordeaux / Andorra
Posts: 7923

United Kingdom 2013 Range Rover Vogue SE SDV8 Santorini Black

If they are lying flat, I wouldn't have thought excessive weight on the tailgate - I would have thought a block would concentrate the weight more.

How far are you transporting them ? If in doubt, make 2 trips Thumbs Up

+1 on the properly venting the cabin

Post #396303 15th Jul 2016 10:27pm
View user's profile Send private message View poster's gallery Reply with quote
fisha



Member Since: 25 Sep 2009
Location: Scotland
Posts: 1350

2015 Range Rover Autobiography SDV8 Aruba

I've driven with loads hanging out the tailgate. Those have been ones where the bottom tailgate is down and the upper one is in the closed position.

The car senses why you are doing and stops beeping after a short while. I would have the rear seats double folded over so the boot space is totally flat and not use any blocks. The reality is that the lower tailgate can take full size adults sitting on it so spreading the load you describe across the boot floor and tailgate is no issue.

That being aaid I've not done it for more than a few miles. I wouldn't want to. Do it for anything more than 20mins of driving personally. V8 or else ...

Post #396312 16th Jul 2016 5:25am
View user's profile Send private message View poster's gallery Reply with quote
stan
Site Moderator


Member Since: 13 Jul 2010
Location: a moderate moderated moderator moderating moderately in moderation
Posts: 35264

United Kingdom 

if you have the tailgate down you can't see the reg number which is illegal.... ... - .- -.




Y. O. L. O.
.

Post #396316 16th Jul 2016 5:42am
View user's profile Send private message View poster's gallery Reply with quote
CS



Member Since: 14 Apr 2015
Location: Edinburgh
Posts: 1373

Scotland 2017 Range Rover Autobiography 5.0 SC V8 Corris Grey

If you have a towbar you'd be better hiring a trailer.

The payload for a 4.4 TDV8 is 375 - 500 kg per my brochure, 375 - 460 for 5.0SC, so check you plus the sleepers is OK. Tumble the rear seats so you have as much as possible inside the vehicle and a flat load area. Secure the load properly, it would be dangerous if a sleeper fell out, as well as an offence. I have driven with the lower tailgate open and the upper closed for shortish distances, one does get fumes into the cabin, it can be unpleasant and open windows and good airflow are definitely advisable. You do need to display a rear number as well as something to show where the loaded vehicle ends. Only Range Rovers since 1988

Post #396343 16th Jul 2016 10:13am
View user's profile Send private message View poster's gallery Reply with quote
kingpleb



Member Since: 07 Jun 2011
Location: Maybe here. Maybe there, I get everywhere!
Posts: 8455

United Kingdom 2005 Range Rover Vogue Td6 Bonatti Grey

If the rear seats are down and the beams pass over the hump you'll put more weight and stress on the lower tailgate straps thanif you use even 1/2" riser blocks before the tailgate flap. FFRR MY06 facelift With TDV8 Alloys Zeros/ATR's
Mantec Sump Guard, Rigid Load liner, MY10 BT upgrade.

Post #396440 16th Jul 2016 11:09pm
View user's profile Send private message View poster's gallery Reply with quote
northernmonkeyjones



Member Since: 24 Mar 2012
Location: derby
Posts: 8503

United Kingdom 2016 Range Rover Autobiography SDV8 Santorini Black

I don't reckon the sleepers will be much more than 50kg each. I have just had some 9"x4" oak beams to make mantles out of, they were easily man portable. I don't think loading will be an issue. The load Bed with the seats folded is only about 1.7m so they will stick out of the boot about 900mm so should overhang the tailgate by about 200mm appx.

I agree that if you can rent a trailer, then do so, if you can get them delivered then do that as even clean new oak will make a mess if it's straight out of the sawmill. There is nothing that can't be fixed with a hammer😜😜
FFRR 4.4 SDV8 Autobiography Santorini Black.
Fiat 500x 1.4 multiair Lounge 2015
2010 LR D4 Commercial 2.7 TDV6

Post #396508 17th Jul 2016 6:07pm
View user's profile Send private message View poster's gallery Reply with quote
Terrier



Member Since: 17 Dec 2015
Location: Yorkshire
Posts: 51

Thanks for the replies guys. I've got a witter bike rack for the tow bar, so shall use this to give her that extra length, as well as keeping the number plate visible.

Thanks again, happy motoring!

Post #396519 17th Jul 2016 7:54pm
View user's profile Send private message View poster's gallery Post Reply
Post Reply  Back to top
Page 1 of 1
All times are GMT

Jump to  
Previous Topic | Next Topic >
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



Site Copyright © 2006-2024 Futuranet Ltd & Martin Lewis
fullfatrr.com RSS Feed - All Forums


Switch to Mobile site