I'm trying to remove the Passenger Side Air vent but struggling.

I have a MY2012 but am following from the previous manual 2006 to 2010 as I think it's the same as below.

Click image to enlarge

On mine you pull them into the centre of the vent whilst looking into the vent. I use a small screwdriver and try to free one side first and hold that side out, with fingers in the top part of vent, before doing the other side.

14 pictures down on the first page... not exactly the same as yours but not far off....

http://www.fullfatrr.com/forum/post300444.html#300444 Pete

__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Parchment over Navy Interior. Sold
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand, Jet Interior. Sold
2002 L322 Vogue 4.4 V8 Epson Green, Ivory over Aspen Interior (Fatty Offroader) Sold
-Click for Project Fatty off roader-

Thats great, many thanks.

Look very fiddly...

Ok. I've got most of it out but just can't get the Portable Camea dock removed.

The manual says remove the 2 Screws, but I can't see any on MY2012 model.

Click image to enlarge

Ok made some more progress, but am struggling yo remove the Blue RF cable plug from the back of the Portable Camera. Any ideas how to release the little Blue connector ? There is so little room to get to it because the cable is so tight holding the Glove Box Facia back on.

Sorry mine isn't that posh....  Pete

__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Parchment over Navy Interior. Sold
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand, Jet Interior. Sold
2002 L322 Vogue 4.4 V8 Epson Green, Ivory over Aspen Interior (Fatty Offroader) Sold
-Click for Project Fatty off roader-

Sorry to be nosey.......... But what are you doing behind there? What are you fitting/repairing/removing?

On another note, I was looking at retro fitting a venture cam, done searching on here and net but no one seems to have claimed to have done it. So had a look at the wiring I can see on your photos and yeah it looks very tight. Prob why no one has fitted one in.

I'm replacing the Upper Glove Box Facia Trim that includes the Upper Glove Box hinges for the Glove Box lid.
Unfortunately one of the hinges broke, so it had to be done. I have removed it all now and just need to get the Venture Cam Holder removed from the old one before assembling the new Dash Facia back in the vehicle.

Would I do it again ? Nope...

The blue plug i assume is the fakra lead? If so, there is a small raised square on the side, that needs depressing and it pulls straight off... Use a small electrical screwdriver AND BE GENTLE!!!