I'm getting a creaking noise from the passenger side front wheel (08 tdv8). It sounds like a loud clicking or creaking when turning right. Difficult to describe and I'm going to whip the wheel off tomorrow. Anyone got any ideas what to check and how to check it? My Previous RR's!
2018 P400e Autobiography
2008 TDV8 Vogue
2006 TD6 Vogue
2007 TDV8 Vogue
2007 RRS (I know, it doesn't count!)
2005 4.4 Vogue on LPG
2005 TD6 Vogue
2003 4.4 Vogue
2001 4.6 HSE
2000 2.5 DHSE
1999 4.6 HSE
1997 4.6 HSE on LPG
1995 2.5 DSE
1989 3.9 EFI classic
1988 3.5 EFI classic

That happened mine like a squeaky pram sound? It was the lower control arm bush on the front I believe that needed replaced. Present :2008 TDV8 HSE
Gone Audi A5 2.7TDI
Gone Discovery 3 HSE
Gone Mercedes CLK
Gone Range Rover 2.5 DSE

This one??

http://www.eurocarparts.com/mobile/ecp/c/L...amp;000320 My Previous RR's!
2018 P400e Autobiography
2008 TDV8 Vogue
2006 TD6 Vogue
2007 TDV8 Vogue
2007 RRS (I know, it doesn't count!)
2005 4.4 Vogue on LPG
2005 TD6 Vogue
2003 4.4 Vogue
2001 4.6 HSE
2000 2.5 DHSE
1999 4.6 HSE
1997 4.6 HSE on LPG
1995 2.5 DSE
1989 3.9 EFI classic
1988 3.5 EFI classic

Yes that was gone on mine and was cause of squeaking.  Present :2008 TDV8 HSE
Gone Audi A5 2.7TDI
Gone Discovery 3 HSE
Gone Mercedes CLK
Gone Range Rover 2.5 DSE

Replaced th 3 times on mine, including anti roll bar link bar, lower suspension arm twice, anti rollbar, front shock and bag, lower ball joint, and still have the crack on turning right and running over undulatin surfaces, frankly have just given up 0-60 takes 5 and a half seconds...and about 17 gallons of fuel....

Current fleet
2005 RR td6
1997 300 Discovery
2005 Subaru Legacy Outback (the wife's)
1981 2.5 Opel Commodore

Who do you use Ed to do your servicing etc ? Present :2008 TDV8 HSE
Gone Audi A5 2.7TDI
Gone Discovery 3 HSE
Gone Mercedes CLK
Gone Range Rover 2.5 DSE

hoppy_70 wrote:

This one??

http://www.eurocarparts.com/mobile/ecp/c/L...amp;000320

had same problem with mine and i do recommend that you either get a 6 tonne press or buy the whole unit with the bush already pushed in,as pushing the bushes into the round arm bit is a nightmare...thought id save few quid by only buying the bush rather than the whole unit,,wish i hadnt,,was a nightmare to push out and an even bigger nightmare getting the bush back in,,ended up taking the bushes to a local garage who has a 10 tonne press,as apparently you need a minimum force of 6 tonne to get the bushes in without defacing them using the old sledge hammer method...