| Topic Starter |
Message |
 Windshield wiper arm removal |
paneldamage
 25th Dec 2013 4:15pm
|
Forum: Technical (L322) · Replies: 10 · Views: 4302 · Subject: Windshield wiper arm removal |
The angled/grooved seating plate is pressed on to the spindle, it needs a puller to get it off. You don't need to remove it to change the angle of the arm though.
A word of warning though, the seatin ... |
| External door trim |
paneldamage
22nd Dec 2013 7:35pm
|
Forum: Technical (L322) · Replies: 1 · Views: 1175 · Subject: External door trim |
| The lower wing plastic trim panel is adjustable for position, it should not be but it's not terribly well made and can be easily moved or knocked. Try slackening the clamp screw amend easing it along ... |
| Our new one!!! |
paneldamage
17th Dec 2013 7:55pm
|
Forum: My Range Rover · Replies: 49 · Views: 16764 · Subject: Our new one!!! |
But did I not read somewhere - a Gary Elliot comment perhaps- that it's rare for any FF to make much better than half it's new value at two years old/ average miles?
Lovely looking car, I think the ... |
| Looking to come back to a FFRR Advice please... |
paneldamage
16th Dec 2013 11:15pm
|
Forum: General · Replies: 26 · Views: 7848 · Subject: Looking to come back to a FFRR Advice please... |
| Yes, they were standard wheels for that era. The only non factory fitting I can see is the chrome thingy on the lower tailgate in the centre. |
| Horns - where are they |
paneldamage
16th Dec 2013 10:19pm
|
Forum: Technical (L322) · Replies: 17 · Views: 16360 · Subject: Horns - where are they |
| They are bolted to a bracket on the inside face of the bumper armature on the offside.... I think it's easier to go in from the top, if you can take the headlight out easily.... |
| 2010 Facelift Questions |
paneldamage
13th Dec 2013 10:27pm
|
Forum: Maintenance & Mods (L322) · Replies: 16 · Views: 6718 · Subject: 2010 Facelift Questions |
| The brackets fit on to threaded bosses on the inside face of the outer wing.... |
| Front driveshafts |
paneldamage
12th Dec 2013 11:47pm
|
Forum: Technical (L322) · Replies: 11 · Views: 3485 · Subject: Front driveshafts |
| Craig... I assume the shafts are the same after 2006? No different between the TDV8, 4.2, 4.4 ? It's just I can get my hands on a cheap low miles o/s shaft off a TDV8....hoping it fits the 4.2 S/C |
| 2010 Facelift Questions |
paneldamage
12th Dec 2013 10:54pm
|
Forum: Maintenance & Mods (L322) · Replies: 16 · Views: 6718 · Subject: 2010 Facelift Questions |
| The wing-to-bumper mounting brackets are not a straightforward fit on to the earlier wings, also, I assume you have realised you need to cut the flange off the forewardmost edge also? Or fit 2006 onwa ... |
| Front driveshafts |
paneldamage
9th Dec 2013 10:37pm
|
Forum: Technical (L322) · Replies: 11 · Views: 3485 · Subject: Front driveshafts |
| Back to my first point - are all the shafts the same? |
| Front driveshafts |
paneldamage
8th Dec 2013 11:51pm
|
Forum: Technical (L322) · Replies: 11 · Views: 3485 · Subject: Front driveshafts |
| No pulling side to side, stops dead straight, no overheating on the calipers, no drag and no tight spots when spinning the wheels by hand with the car jacked up, had the 4 wheel alignment done |
| Front driveshafts |
paneldamage
8th Dec 2013 11:36pm
|
Forum: Technical (L322) · Replies: 11 · Views: 3485 · Subject: Front driveshafts |
| Not triple positive Adam, thought it was the box, but it does it in or out of gear at different rpm, the only constant being the speed, had the wheels balanced, changed a rumbly bearing, checked the d ... |
| Front driveshafts |
paneldamage
8th Dec 2013 11:00pm
|
Forum: Technical (L322) · Replies: 11 · Views: 3485 · Subject: Front driveshafts |
| Hi All, I have an annoying vibration at around 30-33 mile an hour, think it's a front driveshaft on the offside, out of balance or CV worn, on my 2007 S/C. Can any body confirm if the driveshafts are ... |
| Red light indicator on shift |
paneldamage
4th Dec 2013 9:05am
|
Forum: Technical (L322) · Replies: 4 · Views: 2016 · Subject: Red light indicator on shift |
| The OBD cover being open can do this... |
| Warped High Level Brake Light . . . |
paneldamage
3rd Dec 2013 6:41pm
|
Forum: Technical (L322) · Replies: 8 · Views: 2709 · Subject: Warped High Level Brake Light . . . |
+1 - mine split open along the seam, let water in and knack erred the LEDs , is not very good when you think about it, the replacement was about £60  |
| Heated screen problem, how do I check it? |
paneldamage
1st Dec 2013 9:36pm
|
Forum: Technical (L322) · Replies: 9 · Views: 2707 · Subject: Heated screen problem, how do I check it? |
| Sorry, missed your reply, I mean the outer A pillar covers, they wrap over the plastic scuttle finisher, I seem to recall the connections are in front of the passenger, if you look in the wiki there i ... |
| |
