HELP

Put suspension on bumps stops to get compressor out for a small bit of surgery.
Fixed it and put it back into car, now car wont rise up to normal height.

Have iid tool . Read the manual,but its double dutch to me.

Left car running for 15 mins on fast idle to get air into tank, but still wont rise up.
What am I doing wrong .......grrrrrrrrr

Have you re-enabled the suspension with the iiD and then pressed up on the dash board switch ? 2008 MY Supercharged
Rimini Red / Jet
four zone climate
remote park heater
and no ugly kid windows.
magnus satis quod turpis satis

Hi axle,
Yes and it didn't do a thing.

Do you have any error codes on the system?
Any lights on the suspension selection switch?

I would check for suspension error codes, make a note if any. Clear them. Disable the suspension again if it thinks it's enabled and then re-enable - select a height.

It may not enable if there are faults on the system.

What surgery did you do? There could be an issue there.

Have you disconnected the battery for 15 mins, reset all fault codes ?? If not, see if that makes a difference. MY 2010 5.0 SC Galway green and sand interior!!
Have the Faultmate MSV2 Extreme to be tinkering with the settings etc. !!

Wee Jock, only air susp inactive on dash

Ebajema, no haven't tried that as yet.

Did check/pull the 2 fuses( glovebox and rear),both were good.
When I put the rear back in a got a slight hiss, so something is working a bit.

Hiya,

Is there pressure in the tank? Does the pump run? Is it wired up ok - (both the wiring and pipes)

Just a few things to check

cheers

Simon

Have you tried running the engine and doing a full lock to full lock with the steering wheel?

Did the lock to lock nothing

Don't think the tank is filling up with air, cant here anything.

RP123 wrote:

Hiya,

Is there pressure in the tank? Does the pump run? Is it wired up ok - (both the wiring and pipes)

Just a few things to check

cheers

Simon

littlecub, have you done the above suggestions by Simon........




edited for clarification...... ... - .- -.




Y. O. L. O.
.

If you have an IID tool you can check tank pressures, pump temperature etc. etc. with live data. You can also force it to run with the IID as that's how I fixed mine which was cutting out with a false over temp reading (damp in the connector). I forget how it's done on the IID but it will come under something like Actuator Tests.

Thanks weejock.

Sounds to me like you haven't re-enabled the EAS with the IID....

As an aside, you can also inflate each corner or front and back as well to get it off the bump stops, this is handy if a height sensor goes out, manually fill a corner and the system switches off and just holds the air that is there...

Fix the problem and re-enable the EAS to restore... Pete
__________________________________________________
2014 L405 Autobiography SDV8 4.4 Loire Blue Ebony interior
2011 L322 Vogue SE 4.4 TDV8 Baltic Blue. Sold
2012 L322 Autobiography 5.0 Supercharged Ipanema Sand Sold
2002 L322 Vogue 4.4 V8 Epson Green (Fatty Offroader) Sold
-Click for Project Fatty off roader-

Pulled compressor out this morning and found that one of the smaller airlines wasn't seated properly.

Fixed it and put it back into beast and cleared codes.

Arse end started rising almost immediately,

Took it for a test drive down back paddock.

Up mode works, back to normal then down mode doesn't.

At least its silent when going up.

But why doesn't it want to go down?

Will a battery reset fix this problem?

Have a go with the live data see if there are anomalies showing up in the data somewhere. MY 2010 5.0 SC Galway green and sand interior!!
Have the Faultmate MSV2 Extreme to be tinkering with the settings etc. !!